Install properly.. .
.
1 Allow 3 inches (7.5 cm) between overhead cabi- nets and refrigerator top.
2.Allow at least an inch [2 5 cm] between the refrigerator condenser on the back and the wall
3.Allow % inch (1.25 cm) on each side of the
refrigerator for ease of installatron.
4 If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider
Level refrigerator-freezer.. .
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any Inside labels before using the refrigerator.
To remove any remalnlng glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with dishwashing detergent solutron (1 teaspoon detergent in 1 quart warm water] before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachlorlde, etc. These can damage the materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrlgemtor at the front.
Clean it.. .
Clean your refrigerator before using it.
See cleaning instructions on page 0
Plug it in...
Leveling screw
Right to Raise;
Use ScrewdriverLefl to Lower to Adjust
1.To raise front, turn each screw to the right
2.To lower front, turn each screw to the left
3.Check with level.
Retrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off wlth a switch or pull ohaln. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.