3Installation
Appropriate installation location
•Install your machine in environments which have no risk of freezing and in a stable and level position.
•Do not place your machine on a long pile rug or on similar surfaces.
•Operate your machine in a well ventilated,
•Do not block the air ducts in front of and under the machine with materials such as long pile rugs and wooden bands.
BMake sure that your machine is not placed on the power cable.
BKeep at least 1. 5 cm from the edges of other furniture.
Under Counter Installation
•A special part (Part no 295 950
0100) replacing the top trim must be provided and installed by the Authorized Service in order to use the machine under a counter or in a cupboard. It should never be operated without the top trim.
•Leave at least 3 cm of space between the side and rear walls of the machine and the walls of the counter/cupboard when installing your machine under a counter or in a cupboard.
Use on a washing machine
•A fitting device should be used between the two machines for use on a washing machine. The fitting device
(Part no. 295 560 0100 white/ 295
560 0200 grey) must be installed by the Authorized Service.
•Place the machine on a sound floor. If it is to be placed on top of a washing machine, the approximate weight together may reach 180 kg when they are full. Therefore, the floor must be capable of carrying the load on it!
Adjusting the feet
In order to ensure that your machine operates more silently and
Rotate the feet to adjust until the machine stands level and firmly.
CNever unscrew the adjustable feet from their housings.
Ventilation hose and connection (for products equipped with an outlet vent)
Ventilation hose assures exhausting of the air from inside the machine.
There are 3 air outlets on the rear, left and right sides of a vented dryer. The sides are covered by a replaceable plastic cover.
Stainless sheet metal or aluminum pipes can be used instead of the hose. The diameter of the pipe to be used should be minimum 10 cm.
Maximum hose and pipe lengths are given in the table below.
| Hose | Pipe |
Maximum length | 8 m | 10 m |
|
|
|
1 elbow 45° | ||
|
|
|
1 elbow 90° | ||
|
|
|
1 elbow 90° short |
| |
|
|
|
1 wall passage | ||
|
|
|
CEach elbow and other passages should be subtracted from the above maximum length.
To connect a ventilation hose;
1.Fit the hose adaptor (90° or flat adaptor) by pressing it on the air outlet at the rear of your machine. Close the remaining 2 air outlets with plastic covers.
2.Connect the air outlet hose to the hose spacer piece (90° or flat adaptor) by turning it
3.Make the hose passages as shown below.
6 - EN
