the sponge does not run over the plastic frame. Misplacing will lead unsatisfactory filtering and may cause a drop in the performance of or damage to your machine.
CA spare “Filter Drawer Sponge” and a spare “Condenser Sponge” piece are supplied together with the machine.
You must be careful not the lose these spare parts.
Sensor and drum fin
There are humidity sensors in your machine that detect whether the laundry is dry or not.
To clean the sensors and drum fin;
1Open the cover of your machine.
2 Allow the machine to cool off if drying has been carried out.
3 Wipe the metal sensors with a soft cloth, dampened with vinegar and dry them.
C Clean metal sensors 4 times a year.
ANever use solvents, cleaning agents or substances alike when cleaning as these might cause fire and explosion!
ACondensed water is not drinkable!
If you forget to drain the water tank, your machine will stop during the following drying cycles when the water tank is full and the "Tank Full" warning light will light on. If this is the case, press the "Start/ Pause/Cancel" button to resume the drying cycle after draining the water tank. In order to drain the water tank;
1Carefully pull the water tank to take it out.
3Drain the water.
4If there is lint accumulation in the cover, clean it and press to close.
5Slide in the water tank until it stops.
Water tank (for products equipped with a Condenser and a Heat pump)
The moisture in the damp laundry is taken from the laundry and condensed. Drain the water tank after each drying cycle or during drying when "tank full" warning light comes on.
C You can use the water in the water tank in your steam irons or air humidifiers.
A Never take out the water tank when the program is running!
19 - EN
