Blomberg TKF 7230 manual Progress of program, Changing the program after the program has started

Progress of program

Progress of a running program is shown through the program follow-up indicator. At the beginning of every program step, the relevant indicator lamp will light up and light of the completed step will turn off.

"Drying":

-Drying level will be illuminated during the whole drying process until the drying degree reaches "iron dry".

"Iron Dry":

-Starts to illuminate when the drying degree reaches "iron dry" step and remains illuminated until the next step.

" Cupboard Dry":

-Starts to illuminate when the drying degree reaches " Cupboard dry" step and remains illuminated until the next step.

“Cooling”:

-It lights up during the 4-minute cooling phase at the end of drying.

“Final / Anti-creasing”:

-Illuminates when the program comes

to an end and anti-creasing function is activated.

Important:

If more than one LED light up or flash concurrently, it means there is malfunctioning or a failure (please see, Solution suggestions for problems).

Changing the program after the program has started

You can use this feature after your machine has started to dry your clothes under higher or lower temperatures.

For example;

Press and hold the “Start/Pause/Cancel” button for about 4 seconds to “Cancel” the program in order to select “Extra Dry” program instead of “Iron Ready” program. Select the “Extra Dry” program by rotating the

program knob.

Press "Start/Pause/Cancel" button to start the program.

CThe program which is selected first will go on even if the program selection button is moved and another program mode is selected while the machine is operating. You must cancel the ongoing program in order to change the drying program. (See, Ending the program through canceling)

Adding/removing laundry in standby mode

In order to add or take out laundry after the start-up of the program;

1. Press the “Start/Pause/Cancel” button to switch the machine to “Pause” mode. Drying process will stop.

2. Open the door at Pause position and close it again after adding or taking out laundry.

3. Press "Start/Pause/Cancel" button to start the program.

C Any laundry added after the drying process was started may cause the already dried clothes in the machine intermingle with wet clothes and the result will be wet laundry after the drying process is over.

C Laundry may be added or taken out as much as desired during a drying process, but as this process will interrupt drying continuously, it will extend

the program duration and increase energy consumption. Therefore, it is recommended to add laundry before the drying program is started.

Child-proof lock

There is a childproof lock to prevent any program interruption due to the pressing of keys while the program is on. In order to activate the childproof lock, press on the “Audio Warning” and “time delay” buttons simultaneously for 2 seconds. The “Childproof lock” will be activated and a warning led will light up.

15 - EN