ASSEMBLY
Read these instructions and this manual in its entirety before you attempt to assemble or operate your new lawn mower.
IMPORTANT: THIS LAWN MOWER IS SHIPPED WITH- OUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.
TO REMOVE LAWN MOWER FROM CARTON
1.Remove loose parts included with mower.
2.Cut down two end corners of carton and lay end panel down flat.
3.Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to upper handle.
4.Roll lawn mower out of carton and check carton thorougly for additional loose parts.
HOW TO SET UP YOUR LAWN MOWER
TO UNFOLD HANDLE (See Fig 1)
IMPORTANT: Unfold handle carefully so as not to pinch or damage control cables.
1.Raise handles until lower handle section locks into place in mowing position.
2.Remove protective padding, raise upper handle section into place on lower handle and tighten both handle knobs.
3.Remove handle padding holding operator presence control bar to upper handle.
Your lawn mower handle can be adjusted for your mowing comfort. Refer to "Adjust Handle" in the Service and Adjust- ments section of this manual.
OPERATOR PRESENCE
CONTROL BAR
UPPER HANDLE
LIFT UP
LIFT UP
MOWING POSITION
LOWER HANDLE
FIG. 1
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a mulcher. To convert to bagging or discharging; See "TO CONVERT MOWER" in the operation section of this manual
TO ASSEMBLE & ATTACH GRASS CATCHER (See Figs. 2A & 2B)
1.Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top.
2.Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using.
3.Lift the rear door of the lawn mower and place the grass catcher frame side hooks onto the door pivot pins.
4.The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame.
CAUTION: Do not run your lawn mower without clipping deflector or approved grass catcher in place. Never attempt to operate the lawn mower with the rear door removed or propped open.
CATCHER
FRAME
HANDLE
| VINYL | |
| BINDING | |
| FRAME | |
| OPENING | |
| FIG. 2A | |
PIVOT PINS | GRASS CATCHER | |
FRAME HANDLE | ||
|
GRASS CATCHER
FRAME HOOK
FIG. 2B
5