Husqvarna 961450011 warranty Lawn Mower, Tires, Drive Wheels, Blade Care

Page 11

MAINTENANCE

LAWN MOWER

Always observe safety rules when performing any main- tenance.

TIRES

•Keep tires free of gasoline, oil, or insect control chem- icals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

DRIVE WHEELS

Check wheels each time before you mow to be sure they move freely.

The wheels not turning freely means trash, grass cuttings, etc. are in the drive wheel or dust cover area and must be cleaned to free drive wheels. If necessary to clean the drive wheels, be sure to clean all wheels.

1.Remove hubcaps, locknuts and washers.

2.Remove wheels from wheel adjusters.

3.Remove any trash or grass cuttings from inside the dust cover, pinion and/or drive wheel gear teeth.

4.Put wheels back in place.

NOTE: If after cleaning, the drive wheels do not turn freely, contact a qualified service center.

BLADE CARE

For best results, mower blade must be kept sharp. Replace bent or damaged blades.

CAUTION: Useonlyareplacementblade approved by the manufacturer of your mower. Using a blade not approved by the manufacturer of your mower is hazardous, could damage your mower and void your warranty.

2.Install debris shield.

3.Position blade on the blade adapter.

IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON BLADE ADAPTER.

4.Be sure the trailing edge of blade (opposite sharp edge) is up toward the engine.

5.Install the blade bolt with the lock washer and hardened washer into blade adapter and crankshaft.

6.Use block of wood between blade and lawn mower hous- ing and tighten the blade bolt, turning clockwise.

•The recommended tightening torque is 35–40 ft. lbs.

IMPORTANT: BLADE BOLT IS HEAT TREATED. IF BOLT NEEDS REPLACING, REPLACE ONLY WITHAPPROVED BOLT.

 

CRANK-

BELT RE-

SHAFT

KEYWAY

TAINER

 

BLADE

 

ADAPTER

KEY

 

DEBRIS

TRAILING

EDGE

SHIELD

 

HARDENED

BLADE

WASHER

 

 

LOCK WASHER

 

BLADE BOLT

TO REMOVE BLADE (See Fig. 13)

1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

2.Turn lawn mower on its side. Make sure air fi lter and carburetor are up.

3.Use a wood block between blade and mower housing to prevent blade from turning when removing blade bolt.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

4.Remove blade bolt by turning counter-clockwise.

5.Remove blade and attaching hardware (bolt, lock washer and hardened washer).

6.Remove debris shield.

NOTE: Remove the blade adapter and check the key inside hub of blade adapter. The key must be in good condition to work properly. Replace adapter if damaged.

TO REPLACE BLADE (See Fig. 13)

1. Position the blade adapter on the engine crankshaft. Be sure key in adapter and crankshaft keyway are aligned; and that the drive belt is inside the tab of the belt retainer.

11

FIG. 13

TO SHARPEN BLADE (See Fig. 14)

NOTE: We do not recommend sharpening blade - but if you do, be sure the blade is balanced. An unbalanced blade will cause eventual damage to lawn mower or engine.

•The blade can be sharpened with a fi le or on a grind- ing wheel. Do not attempt to sharpen while on the mower.

CENTER HOLE

5/8" BOLT OR PIN

BLADE

FIG. 14

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Operator’s Manual Manuel de L’Opérateur III. Children Safe Operation Practices for Walk-Behind MowersGeneral Operation II. Slope OperationTable of Contents To Remove Lawn Mower from Carton AssemblyHOW to SET UP Your Lawn Mower To Install AttachmentsKnow Your Lawn Mower Meets Cpsc Safety RequirementsOperation To Convert Mower HOW to USE Your Lawn MowerEngine Speed Engine Zone ControlSimple Steps to Remember When Converting Your Lawn Mower To Start Engine Before Starting EngineMulching Mowing Tips Mowing TipsBefore Each USE MaintenanceLubrication Chart General RecommendationsBlade Care Lawn MowerTires Drive WheelsGear Cases EngineTo Change Engine OIL See Figs Grass CatcherMuffler CleaningWater Washout Feature See Fig AIR Filter See FigTo Remove Drive Belt See Figs Service and AdjustmentsTo Adjust Cutting Height Rear DeflectorFront To Replace Drive Belt See FigsHandle See Figs To Adjust Handle See FigStorage CarburetorCylinder OtherFuel System Engine OILProblem Cause Correction Troubleshooting PointsConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Consumer Wheeled Limited Warranty Chart Faites II. Fonctionnement Dans LES PentesFonctionnement Général III. EnfantsIV. Manipulation Sûre DU Carburant SommaireSpécifications DE Produit Responsabilités DU ClientComment Monter Votre Tondeuse À Gazon Installer LES AccessoiresMontage Pour Enlever LA Tondeuse À Gazon DU CartonRencontre LES Exigences DES Normes DE Sécurité Cpsc UtilisationConnaissez SUR Votre Tondeuse À Gazon Contrôle DE LA Zone DU Moteur Commande DE LA Vitesse DE MoteurRéglages DE LA Commande Comment Utiliser Votre Tondeuse À GazonDechargement Latéral Voir Fig Pour Vider LE RAMASSE-HERBE Voir FigPour Arrêter LE Moteur Voir Fig Avant DE Démarrer LE MoteurAjouter DE L’HUILE Voir Fig Ajoutez DE L’ESSENCE Voir FigConseils DE BROYER/TONDRE Conseils DE TonteAvant Chaque Utilisation Recommandations GénéralesEntretien Tableau DE LubrificationSoin DE Lame PneusRoues Motrices Changer L’HUILE DE Moteur Voir Figs et MoteurRAMASSE-HERBE Lubrification DU MoteurLE Dispositif DE Lavage DE L’EAU Voir Fig NettoyageSilencieux Bougie D’ALLUMAGEPour Enlever LA Courroie D’ENTRAÎNEMENT Voir Figs et Révision ET RéglagesPour Régler LA Hauteur DE Coupe Déflecteur ArrièreAvant Pour Remplacer LA Courroie D’ENTRAÎNEMENT Voir Figs etCarburateur EntreposagePour Régler LE Guidon Voir Fig Vitesse DE MoteurCylindre AutresSystème D’ESSENCE Huile DE MoteurGuide DE Dépannage Problème Cause SolutionAVERTISSEMENTS, Limitations ET Exclusions Comment Obtenir LE Service Location toute Location toute 02/05/2012 by

961450011 specifications

The Husqvarna 961450011 is a highly versatile and dependable lawn mower designed for homeowners who seek to maintain a pristine lawn with ease and efficiency. This model features a durable and efficient engine, ensuring a powerful performance capable of handling various types of grass and terrain. One of its main features is the robust 17 HP Briggs & Stratton engine, which provides ample power for cutting through thick and dense grass, while also ensuring fuel efficiency.

Equipped with a 42-inch cutting deck, the Husqvarna 961450011 allows for wider cutting paths, meaning larger areas can be mowed in less time compared to traditional push mowers. The cutting deck is designed with a clever design for optimal grass dispersion, preventing clumping and ensuring a neat finish. This deck is also adjustable, offering multiple cutting heights to cater to different grass types and personal preferences. Whether you prefer a close trim or a slightly higher cut, this mower can adapt to your needs.

Another noteworthy technology incorporated into this model is the hydrostatic transmission, which allows for smooth and precise speed adjustments. This feature enhances the operator's control, making it easier to maneuver around obstacles and navigate tight spaces. Additionally, the steering wheel control offers a comfortable grip and promotes easy handling, further reducing operator fatigue during longer mowing sessions.

Safety is a priority with the Husqvarna 961450011. It comes with a safety switch that ensures the engine cuts off when the operator leaves the seat, minimizing the risk of accidents. The design also includes an innovative reverse mowing feature, enabling grass cutting while moving backward, which adds convenience, especially in complex yard layouts.

Moreover, the mower boasts an ergonomic design, featuring a comfortable seat and user-friendly controls, allowing any operator, regardless of experience, to effectively manage their mowing tasks. The durability of the construction ensures that users will enjoy years of reliable service, while the sleek design encapsulates both form and function.

In summary, the Husqvarna 961450011 is a reliable, feature-rich lawn mower. Its powerful engine, adjustable cutting deck, hydrostatic transmission, and emphasis on safety make it an excellent choice for homeowners looking to maintain their lawns seamlessly and effectively.
Top Page Image Contents