Husqvarna 961450011 warranty Before Starting Engine, To Start Engine

OPERATION

TO EMPTY GRASS CATCHER (See Fig. 9)

1.Lift up on grass catcher using the frame handle.

2.Remove grass catcher with clippings from under lawn mower handle.

3.Empty clippings from bag using both frame handle and bag handle.

NOTE: Do not drag the bag when emptying; it will cause unnecessary wear.

GRASS

CATCHER

FRAME

HANDLE

BAG

HANDLE

FIG. 9

BEFORE STARTING ENGINE

ADD OIL (See Fig. 10)

Your lawnmower is shipped without oil in the engine. For type and grade of oil to use, see “ENGINE” in the Mainte- nance section of this manual.

CAUTION: DO NOT overfill engine with oil, or it will smoke heavily from the muffler on startup.

1.Be sure lawnmower is level.

2.Remove oil fill cap/dipstick from oil fi ll spout.

3.You recieve a container of oil with the unit. Slowly pour the entire container down the oil fi ll spout into the engine.

4.Insert and tighten oil fill cap/dipstick.

IMPORTANT:

•Check oil level before each use. Add oil if needed. Fill to full line on dipstick.

•Change the oil after every 25 hours of operation or each season. You may need to change the oil more often un- der dusty, dirty conditions. See “TO CHANGE ENGINE OIL” in the Maintenance section of this manual.

GASOLINE

FILLER CAP

ENGINE

OIL CAP

FIG. 10

ADD GASOLINE (See Fig. 10)

•Fill fuel tank to bottom of tank fi ller neck. Do not over- fi ll. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage.

Acidic gas can damage the fuel system of an engine while in storage. To avoid engine prob- lems, the fuel system should be emptied before storage of 30 days or longer. Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO STOP ENGINE (See Fig. 11)

•To stop engine, release operator presence control bar. Wait until blade and all moving parts have stopped and turn fuel valve to OFF position if you do not intend to restart the engine soon.

TO START ENGINE

NOTE: Due to protective coatings on the engine, a small amount of smoke may be present during the initial use of the product and should be considered normal.

1.Be sure fuel valve is in the ON position.

2.Move choke lever to ON ( ) position.

3.Hold operator presence control bar down to the handle and pull starter handle quickly. Do not allow starter rope to snap back.

NOTE: The choke lever automatically begins moving to the OFF position when operator presence control bar is held down to handle.

8