Husqvarna 96045003000, 532 44 05-66 Attach Mower Side Suspension Arms a to Chassis See Fig

Page 20

SERVICE AND ADJUSTMENTS

6.ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS (See Fig. 28)

•Position front hole in side suspension arm (A) over pin on outside of tractor chassis and secure with large washer and large retainer spring (B).

•Repeat on opposite side of tractor.

A

B

 

D

 

A.MOWER SIDE SUSPENSION ARMS

 

B. RETAINER SPRING

 

D. RIGHT SIDE REAR MOWER BRACKET

 

Fig. 28

7. ATTACH REAR LIFT LINKS (C) (See Fig. 29)

•Insert rod end of rear lift link (C) into hole (U) in tractor lift shaft suspension arm and pivot link down to mower.

•Lift rear corner of mower and position slot in link as- sembly over pin on rear mower bracket (D) and secure with large washer and large retainer spring.

•Repeat on opposite side of tractor.

U

C

D

C. REAR LIFT LINK(S)

D. RIGHT SIDE REAR MOWER BRACKET

U. HOLE

Fig. 29

8 ATTACH FRONT LINK (E) (See Fig.30)

•Turn steering wheel to position wheels straight forward.

•From front of tractor, insert rod end of front link (E) through front hole in tractor front suspension bracket (F).

•Move to left side of mower and and insert large retainer spring (G) through hole in front link (E) behind front suspension bracket (F).

•Insert other end of link (E) into hole in front mower bracket (H) and secure with washer and small retainer spring (J).

NOTE: Requires deck lifting.

FRONT LINK

LOCATION

M

H

F

G E

J

E.FRONT LIFT LINK ASSEMBLY

F.FRONT SUSPENSION BRACKET

G.LARGE RETAINER SPRING

H.FRONT MOWER BRACKET

J.SMALL RETAINER SPRING M. ENGINE CLUTCH PULLEY

Fig. 30

9INSTALL BELT ON ENGINE CLUTCH PULLEY (M) (See Fig. 19 & 31)

•Disengage belt tension rod (K) from locking bracket (L).

•Install belt onto engine clutch pulley (M).

M

M.ENGINE

CLUTCH PULLEY

Fig. 31

IMPORTANT: Check belt for proper routing in all mower pulley grooves and under mandrel covers.

•Engage belt tension rod (K) on locking bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents YTH2348 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerService REMINDER/HOUR Meter Using the Reverse Operation SystemReverse Operation System ROS To Transport See FigsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionMaintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Deck Washout Port See Fig Cleaning IN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs ANTI-SWAY BAR S Turn Steering Wheel Left and Position Mower See FigAttach Mower Side Suspension Arms a to Chassis See Fig To Level Mower Turn nut right Turn nut left To raise mowerMower Drive Belt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig Mower Drive Belt RemovalTo Start Engine with a Weak Battery See Fig Weak or Dead Fully Charged BatteryTo Check Brake Front Wheel TOE-IN/CAMBERREMOVAL/REPLACEMENT To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine continues KEY Part Description DecalsWheels and Tires Schematic SCH12Electrical Socket Asm. Bulb Twistlock 208 Chassis Drive 196Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Spark Arrester KIT EngineEngine Power Rating Information KEY Part NO. NO. DescriptionSteering Assembly Seat Assembly Mower Deck KEY Part NO. NO. Description Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Front Mounted Deck Riders Engine Transmission 11.05.10 JA
Top Page Image Contents