Husqvarna 532 44 05-66, 96045003000 Tractor, Brake Operation, Tires, Blade Care, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any main- tenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved sur- face,thenbrakemustbeserviced.(See“TOCHECKBRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See PSI on tires).

•Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OP- ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

ROS "ON" Position

Engine "ON" Position

(Normal Operating)

 

02828

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

BLADE CARE

For best results mower blades must be sharp. Replace worn, bent or damaged blades.

CAUTION: Use only a replacement blade approved by the manufacturer of your tractor. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 13)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new blade with stamped "GRASS SIDE" facing the ground.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: Special blade bolt is heat treated.

MANDREL ASSEMBLY

 

BLADE

BLADE BOLT

STAR

(SPECIAL)

 

CENTER HOLE

Fig. 13

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Remove terminal guard.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this

15manual).

Page 14 Page 16
Image 15
Page 14 Page 16
Contents YTH2348 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Toremovetractorfromcarton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Reverse Operation System ROS on Position Know Your TractorHOW to USE Your Tractor To Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Transport See Figs Service REMINDER/HOUR MeterUsing the Reverse Operation System Reverse Operation System ROSTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig Turn Steering Wheel Left and Position Mower See Fig ANTI-SWAY BAR SAttach Mower Side Suspension Arms a to Chassis See Fig Turn nut right Turn nut left To raise mower To Level MowerMower Drive Belt Removal Mower Drive Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigWeak or Dead Fully Charged Battery To Check BrakeTo Adjust Carburetor REMOVAL/REPLACEMENTTo Adjust Throttle Control Cable To Adjust Choke ControlEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine continues Decals Wheels and TiresKEY Part Description SCH12 SchematicElectrical Socket Asm. Bulb Twistlock 208 Chassis 196 DriveBolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Engine Spark Arrester KITKEY Part NO. NO. Description Engine Power Rating InformationSteering Assembly Seat Assembly Mower Deck KEY Part NO. NO. Description Mower Lift Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Front Mounted Deck Riders Engine Transmission 11.05.10 JA

532 44 05-66, 96045003000 specifications

The Husqvarna 96045003000,532 44 05-66 is a powerful and innovative riding mower designed for residential lawn care. This model stands out due to its combination of performance, durability, and user-friendly features, making it a popular choice among homeowners seeking an efficient mowing solution.

At the heart of the Husqvarna 96045003000 is its robust engine. It is equipped with a premium quality engine that offers reliable performance and excellent fuel efficiency. The powerful motor enables the mower to tackle even the toughest grass, ensuring a pristine finish to your lawn with every cut. Along with this efficiency, the mower is also designed to minimize emissions, promoting a more environmentally friendly operation.

A standout feature of this model is its advanced cutting deck technology. The 42-inch cutting deck size allows for a wide cutting path, reducing the number of passes needed to cover larger areas. The design of the cutting deck ensures even grass distribution and enhanced mulching capabilities, allowing users to finely chop grass clippings for better nutrient return to the soil.

Equipped with the latest in ergonomic design, the Husqvarna 96045003000 prioritizes user comfort. It features an adjustable seat that ensures a comfortable riding position for various user heights and preferences. The steering system provides precise control, making it easy to navigate around obstacles in your yard.

The mowing height can easily be adjusted to suit different grass types and conditions, providing versatility for varying lawn care needs. This adaptability allows homeowners to maintain their lawns at desired lengths for aesthetic appeal and health.

Additionally, Husqvarna incorporates advanced safety features into this model. The cutting blade automatically disengages when the operator leaves the seat, minimizing the risk of accidents. The mower also comes with easy-to-access controls to ensure that all functions are within reach, enhancing operational safety.

In conclusion, the Husqvarna 96045003000,532 44 05-66 offers an excellent balance of power, efficiency, and safety features. Its durable construction and advanced technology make it an essential tool for any homeowner looking to maintain a beautiful lawn with ease.
Top Page Image Contents