Husqvarna 345RX, 343R, 345FXT, 343FR manual KEY to Symbols

Page 2

KEY TO SYMBOLS

Symbols

WARNING! Clearing saws, brushcutters and trimmers can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of the operator’s manual.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

A protective helmet where there is a risk of falling objects

Approved hearing protection

Approved eye protection

Max. speed of output shaft, rpm

Watch out for thrown objects and ricochets.

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Approved eye protection must always be used.

The operator of the machine must ensure, while working, that no persons or animals come closer than 15 metres.

Machines fitted with saw blades or grass blades can be thrown violently to the side when the blade comes into contact with a fixed object. This is called blade thrust. The blade is capable of amputating an arm or leg. Always keep people and animals at least 15 metres from the machine.

Always wear approved protective gloves.

Wear sturdy, non-slip boots.

Only use non-metallic, flexible cutting attachments, i.e. trimmer heads with trimmer cord.

15 m 50FT

15 m 50FT

Other symbols/decals on the machine refer to special certification requirements for certain markets.

2 – English

Image 2
Contents 343F 345FX 345FXT 343FR 343R 345RX EnglishKEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what on the clearing saw? 343R, 345RXWhat is what on the clearing saw? 343F, 345FX, 345FXT What is what on the clearing saw? 343FR General Safety Precautions Personal protective equipmentThrottle lockout Machine′s safety equipmentStop switch Quick release Cutting attachment guardVibration damping system MufflerLocking nut Locking screwSharpening grass cutters and grass blades Cutting equipmentCutting equipment Sharpening the saw blade Trimmer headTransport position, handlebar AssemblyAssembling the handlebar and throttle Assembling the cutting equipment 343FR, 343R, 345RX Fitting the blade guard and saw blade343F, 345FX, 345FXT Standard harness Adjusting the harness and clearing sawFitting other guards and cutting attachments Correct balance Adjusting the harnessTriobalance harness Fuel Fuel safetyFuel Handling Fueling MixingStarting and stopping Starting and StoppingCheck before starting Cold engineHeated handles StartingStopping General working instructions Basic safety rulesWorking Techniques ABC of clearingForestry clearing using a saw blade Working methodsGrass clearing using a grass blade Brush cutting with a saw bladeGrass trimming with a trimmer head TrimmingMaintenance CarburetorAdjusting the start throttle speed 343FR, 343R, 345RX Fine adjustment of the idle speed TCorrectly adjusted carburetor High speed jet HCooling system Cleaning the air filterMuffler Air filterSpark plug Bevel gearDrive shaft Winter useTemperature 0C 32F or colder Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical data345FX 345FXT Engine 343FR Centre hole in blades/cutters, Ø 25,4 mm Technical Data Federal Emission Control Warranty Statement Your Warranty Rights and ObligationsPage Clic 35-50 NM 095-.130~ 3,5 m Page Mm 9,0 m Mm 7,5 m Mm 6,0 m 15 cm 10 m 10 cm 15 cm Clic 1150276-95 ´z+Re¶5p¨ ´z+Re¶5p¨