Husqvarna 345FXT, 343R, 345RX, 343FR manual Temperature 0C 32F or colder

Page 31

MAINTENANCE

Temperature 0°C (32°F) or colder:

The air filter holder is prepared so it can be changed for use in the cold. Remove the air filter cover and air filter. Turn the winter cover anticlockwise using a screwdriver so that the preheated air from the engine can pass inside the carburettor compartment and prevent, for example, the air filter from icing up (see figure).

For temperatures below -5°C (23°F) and/or in snow conditions there is also:

a special cover for the starter housing

a cover for cylinder cover’s air inlet should be fitted as illustrated.

These reduce the cooling air and prevent large amounts of snow from being sucked into the engine.

IMPORTANT! If the temperature rises above -5°C (23°F) or 0°C (32°F) respectively the machine MUST be restored to its normal set-up. Otherwise there is a risk of overheating, which can cause severe engine damage.

IMPORTANT! Any maintenance other than that described in this manual must be carried out by your servicing dealer (retailer).

IMPORTANT! Use only HUSQVARNA replacement parts. Use of other brands of replacement parts can cause damage to your unit or injury to the operator or others.Your warranty does not cover damage or liability caused by the use of accessories and/or attachments not specifically recommended by HUSQVARNA.

English – 31

Image 31
Contents English 343F 345FX 345FXT 343FR 343R 345RXSymbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the clearing saw? 343R, 345RX What is WHAT?What is what on the clearing saw? 343F, 345FX, 345FXT What is what on the clearing saw? 343FR Personal protective equipment General Safety PrecautionsStop switch Machine′s safety equipmentThrottle lockout Muffler Cutting attachment guardVibration damping system Quick releaseLocking screw Locking nutCutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Sharpening the saw bladeAssembling the handlebar and throttle AssemblyTransport position, handlebar Assembling the cutting equipment 343F, 345FX, 345FXT Fitting the blade guard and saw blade343FR, 343R, 345RX Fitting other guards and cutting attachments Adjusting the harness and clearing sawStandard harness Triobalance harness Adjusting the harnessCorrect balance Fuel Handling Fuel safetyFuel Mixing FuelingCold engine Starting and StoppingCheck before starting Starting and stoppingStopping StartingHeated handles ABC of clearing Basic safety rulesWorking Techniques General working instructionsWorking methods Forestry clearing using a saw bladeBrush cutting with a saw blade Grass clearing using a grass bladeTrimming Grass trimming with a trimmer headCarburetor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburetor Adjusting the start throttle speed 343FR, 343R, 345RXAir filter Cleaning the air filterMuffler Cooling systemWinter use Bevel gearDrive shaft Spark plugTemperature 0C 32F or colder Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical Data345FX 345FXT Engine 343FR Centre hole in blades/cutters, Ø 25,4 mm Technical Data Your Warranty Rights and Obligations Federal Emission Control Warranty StatementPage ~ 3,5 m 095-.130Clic 35-50 NM Page Mm 9,0 m Mm 7,5 m Mm 6,0 m 15 cm 10 m 10 cm 15 cm Clic 1150276-95 ´z+Re¶5p¨ ´z+Re¶5p¨