Husqvarna 345RX Assembly, Assembling the handlebar and throttle, Transport position, handlebar

Page 14

ASSEMBLY

Assembling the handlebar and throttle

CAUTION! Some models have the throttle handle ﬁtted at the factory.

•Remove the screw at the rear of the throttle handle.

•Slide the throttle handle onto the right side of the handlebar, (see diagram).

•Align the screw hole in the throttle handle with the hole in the handlebar.

•Reﬁt the screw in the hole in the rear of the throttle handle.

•Screw the screw through the handle and handlebar. Tighten it.

•Unscrew the knob from the handlebar mounting.

•Position the handlebar as shown. Fit the mounting components and tighten the knob lightly.

343R, 345RX

343F,345FX,345FXT

343FR

•Put on the harness and hang the machine from the support hook. Now make a ﬁnal adjustment so that the machine is in a comfortable working position when it hangs from the harness.

•Tighten the knob.

Transport position, handlebar

•The handlebar can easily be turned to ﬁt along the shaft for easier transportation and storage.

•Loosen the knob.Turn the handlebar clockwise so that the throttle handle rests against the engine.

•Now twist the handlebar around the shaft. Tighten the knob.

•Fit the transport guard to the cutting attachment.

14 – English

Image 14

Contents 343F 345FX 345FXT 343FR 343R 345RX EnglishKEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what on the clearing saw? 343R, 345RXWhat is what on the clearing saw? 343F, 345FX, 345FXT What is what on the clearing saw? 343FR General Safety Precautions Personal protective equipmentThrottle lockout Machine′s safety equipmentStop switch Quick release Cutting attachment guardVibration damping system MufﬂerLocking nut Locking screwSharpening grass cutters and grass blades Cutting equipmentCutting equipment Sharpening the saw blade Trimmer headTransport position, handlebar AssemblyAssembling the handlebar and throttle Assembling the cutting equipment 343FR, 343R, 345RX Fitting the blade guard and saw blade343F, 345FX, 345FXT Standard harness Adjusting the harness and clearing sawFitting other guards and cutting attachments Correct balance Adjusting the harnessTriobalance harness Fuel Fuel safetyFuel Handling Fueling MixingStarting and stopping Starting and StoppingCheck before starting Cold engineHeated handles StartingStopping General working instructions Basic safety rulesWorking Techniques ABC of clearingForestry clearing using a saw blade Working methodsGrass clearing using a grass blade Brush cutting with a saw bladeGrass trimming with a trimmer head TrimmingMaintenance CarburetorAdjusting the start throttle speed 343FR, 343R, 345RX Fine adjustment of the idle speed TCorrectly adjusted carburetor High speed jet HCooling system Cleaning the air ﬁlterMufﬂer Air ﬁlterSpark plug Bevel gearDrive shaft Winter useTemperature 0C 32F or colder Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical data345FX 345FXT Engine 343FR Centre hole in blades/cutters, Ø 25,4 mm Technical Data Federal Emission Control Warranty Statement Your Warranty Rights and ObligationsPage Clic 35-50 NM 095-.130~ 3,5 m Page Mm 9,0 m Mm 7,5 m Mm 6,0 m 15 cm 10 m 10 cm 15 cm Clic 1150276-95 ´z+Re¶5p¨ ´z+Re¶5p¨