ASSEMBLY
•Tighten the trimmer head to a torque of
•To dismantle, follow the instructions in the reverse order.
Fitting other guards and cutting attachments
Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.
H
L 
P
B
A 
M
C
M LA
•Fit the drive disc (B) on the output shaft.
•Centre the metal cup (P) on the drive disc’s blade guide.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
H
C
•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.
•To dismantle, follow the instructions in the reverse order.
Adjusting the harness and clearing saw
WARNING! When using a clearing saw it
!must always be hooked securely to the harness. Otherwise you will be unable to control the clearing saw safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.
Standard harness
Safety release
At the front is an easily accessible, quick release. Use this if the engine catches fire or in any other emergency situation that requires you to free yourself from the machine and harness.
Spreading the load on your shoulders
A
Correct height
1Forestry clearing
The machine should be supported in a harness when forestry clearing so that the cutting equipment is angled slightly forwards in relation to the ground. Adjust the height using the strap on the harness for the support hook.
2Grass clearing
The machine should be supported in a harness when grass clearing so that the cutting equipment is parallel to the ground.
English – 17