Husqvarna W21K, W21SK, W21SBK, W53SBEK, W53SEK, W21KC, W21SKC, W21SBKC manual Cutting height

Page 19

CONTROLS

Cutting height

The cutting deck height is obtained by raising the wheels for low cut and lowering wheels for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.

To change your cutting height, squeeze adjuster lever toward wheel. Move wheel up or down to suit your requirements. Be sure all wheels are in the same setting.

NOTE: Adjuster is properly positioned when plate tab inserts into hole in lever. Also, 9- position adjusters (if so equipped) allow lever to be positioned between the plate tabs.

Ground Drive Bail

The ground drive bail for models so equipped, is used to engage the drive wheels.

The ground drive bail is engaged by pressing the bail forward to engage the drive wheels. Release the ground drive bail to stop rear wheels from driving.

	2
	1
	3
8019-038	8019-039

1.Lever backward to lower mower Lever forward to raise mower

2.Lever

3.Plate Tab

8019-045

Ground drive bail, Models: W21SBK, W53SBEK, W21SBKC

8019-029

Ground drive bail, Models: W21SK, W53SEK, W21SKC

No ground drive bail, Model: W21K, W21KC	8019-046

English-17

Image 19

Contents Operators Manual OPERATOR’S Manual Push Mower Safety InstructionsIntroduction Introduction Introduction Manufacturing Number Good ServiceSymbols and Decals Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Distance from Safety Instructions Safety InstructionsGeneral Use Keep children away from the work area Do as follows Operating on SlopesDo not Children MaintenanceNever fill the fuel tank indoors Transport Customer responsibilities Controls ControlsFuel Shut Off Valve Engine SpeedOperator Presence Control OPC Choke Control All Models USE Full Throttle When MOWING, for best mower performanceThrottle Control All Models Blade Brake Control BBC Ground Drive Bail Cutting heightShut Off Engine To Empty Grass Catcher To Convert MowerEnglish-20 Before Starting Engine OperationTo Start Engine Mowing Transmission SelectorBlade in short cut grass or over a hard level Release OPC bail Self Propelled Models Only Set throttle control to high speed Push Models Only Mowing Tips Mulching Mowing Tips Maintenance MaintenanceMaintenance Schedule Before Each Use General RecommendationsIgnition System Checking the Engines Cooling Air Intake Checking and Adjusting the Throttle Cable and Choke Cable Inspection Replacing Air FilterChecking Tires Replacing the Fuel FilterDrive Wheels Checking the V-belts Always use protective gloves when handling the bladeChecking the Blade Gear Case Blade replacementMuffler CleaningClean Under Drive Cover Grass CatcherTo Remove Drive Belt Adjusting the Lawn MowerTo Adjust Handle Rear DeflectorCleaning and Washing Engine AdjustmentHardware English-41 Engine Lubrication Mower Lubrication ChartLubrication LubricationTo Change Engine Oil Changing the Oil Filter Trouble Shooting Guide Trouble Shooting GuideProblem Cause English-45 112280 R2 03/06/07