OPERATION
TO START ENGINE
NOTE: Due to protective coatings on the engine, a small amount of smoke may be present during the initial use of the product and should be considered normal.
To start a cold engine, push the throttle control lever to the choke position.
Models: W21SBK & W53SBEK, W21SBKC
Pull starter cord briskly. It is not necessary to engage OPC control. Do not engage ground speed control bail. When engine starts, move the throttle control to fast position. Do not allow the starter cord to snap back.
Models: W21SK, W53SEK, W21SKC
Hold Operator Presence Control in engaged position. Do not engage the Ground Speed Control Bail. Pull the starter cord briskly. When the engine starts, move the throttle control to fast position. Do not allow the starter cord to snap back.
Model: W21K, W21KC
Hold Operator Presence Control in engaged position. Pull the starter cord briskly. When the engine starts move the throttle control to fast position. Do not allow the starter cord to snap back.
NOTE: In cooler weather it may be necessary to choke engine. In warmer weather, it may not be necessary to choke the engine. Too much choke may cause engine flooding and prevent the engine from starting. If the engine becomes flooded, wait a few minutes before attempting to start.
3 | 2 |
| |
| 1 |
|
Pull start, Models: W21SBK, W53SBEK, W21SBKC
1.Starter cord
2.OPC
3.Ground speed bail
1 |
2 |
3 |
Pull start, Models: W21SK, W53SEK, W21SKC
1.OPC engaged position
2.Ground speed bail
3.Starter cord
1
2
Pull start, Models: W21K, W21KC
1.OPC engaged position
2.Starter cord