Husqvarna RZ19 CE / 966658901 manual Safety System, Tire Pressures

Page 36

MAINTENANCE

Safety System

The machine is equipped with a safety system that prevents starting or driving under the following conditions.

The engine can only be started when:

1.The mower deck is disengaged.

2.The steering controls are in the outer, locked neutral position.

3.The driver is sitting in the driver’s seat.

4.The parking brake is on.

Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again.

If the machine starts when one of these conditions is not met, turn the machine off and repair the safety system before using the machine again.

Make sure the engine stops when the park brake is not engaged and the operator leaves the seated position.

Check that the engine stops if the mower blades are engaged and the driver temporarily moves off the drivers seat.

8050-020

Start conditions

IMPORTANT INFORMATION

In order to be able to drive, the driver must sit in the seat and release the parking brake before the steering controls can be moved into the neutral position, otherwise the engine will stop.

Tire Pressures

All tires should be at 15 psi / 103 kPa / 1 bar.

8011-564

Tire pressures

36

Image 36
Contents Operator Manual Husqvarna. All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxManual Safety Safety InstructionsNever take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark ArrestorControls Control LocationsSteering Control Levers Ignition Switch Parking BrakeThrottle Control Choke Control RefuelingFuel Shut Off Valve Mower Deck Lifting LeverTracking Always use the high position F to transportBlade Control Lever Bypass LinkageTraining SteeringBefore Starting Starting the EnginePlace controls in neutral position Open the fuel valve Jumper cables To remove cables, reverse orderRunning Operating on Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Maintenance ScheduleBefore After Year Battery To clean battery and terminalsAlways use protective glasses when handling the battery Safety System Tire PressuresBelts Deck BeltTo replace deck belt EZT Belt Cutting BladesAdjusting the Mower Deck Leveling DeckCleaning Removal and installation of caster wheelUse protective glasses when cleaning and washing Caster WheelsLubrication GeneralFront Wheel Mount Front Wheel BearingsEngine Lubrication Steering Control ShaftsTroubleshooting Problem CauseTroubleshooting Service Winter StorageWiring Diagram Technical Data Torque SpecificationsStandard Hardware RZ19 CE Engine TransmissionDimensions RZ19 CE EquipmentProductivity Vibration Equivalent VibrationEU Declaration of Conformity Information Only applicable to European versionsBusiness Name and Address Notified BodyService Journal Delivery ServiceAction Date, mtr reading, stamp, sign Hour Service After the First 10 HoursService Journal At Least Once Each Year Page 115 383927R1 10/26/10