Husqvarna RZ19 CE / 966658901 manual Belts, Deck Belt, To replace deck belt

Page 37

MAINTENANCE

Parking Brake

Visually check that no damage is found on the lever, links, or switch belonging to the parking brake. Perform a standstill test and check that there is sufficient braking action.

To adjust the parking brake, contact the Husqvarna service workshop.

WARNING!

Faulty adjustment can result in reduced braking ability and can cause an accident.

V-belts

Check every 100 hours of operation. Check for severe cracking and large nicks.

NOTE: The belt will show some small cracks in normal operation.

The belts are not adjustable. Replace belts if they begin to slip from wear.

Deck Belt

To replace deck belt

Deck belt removal.

1.Park on a level surface. Apply park brake.

2.Lower the deck to the lowest cutting position.

3.Disengage the clutch by sliding the blade control lever downwards.

4.Carefully lift the belt away from belt keepers and off deck pulleys and remove from deck.

5.Replace belt (refer to the belt routing decal on the deck) and re-engage clutch.

8050-005

Check for proper operation of parking brake

8058-074

Disengage clutch to replace deck belt

8050-013

Check deck belt for excessive wear

37

Image 37

Contents Operator Manual Husqvarna. All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and decalsManual Safety Instructions SafetyNever take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsSteering Control Levers Parking Brake Ignition SwitchThrottle Control Refueling Choke ControlMower Deck Lifting Lever Fuel Shut Off ValveTracking Always use the high position F to transportBypass Linkage Blade Control LeverSteering TrainingStarting the Engine Before StartingPlace controls in neutral position Open the fuel valve To remove cables, reverse order Jumper cablesRunning Operating on Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Schedule MaintenanceBefore After Year To clean battery and terminals BatteryAlways use protective glasses when handling the battery Tire Pressures Safety SystemDeck Belt BeltsTo replace deck belt Cutting Blades EZT BeltLeveling Deck Adjusting the Mower DeckRemoval and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationFront Wheel Bearings Front Wheel MountEngine Lubrication Steering Control ShaftsProblem Cause TroubleshootingTroubleshooting Winter Storage ServiceWiring Diagram Torque Specifications Technical DataStandard Hardware Transmission RZ19 CE EngineRZ19 CE Equipment DimensionsProductivity Vibration Equivalent VibrationOnly applicable to European versions EU Declaration of Conformity InformationBusiness Name and Address Notified BodyDelivery Service Service JournalAction Date, mtr reading, stamp, sign After the First 10 Hours Hour ServiceService Journal At Least Once Each Year Page 115 383927R1 10/26/10