SAFETY INSTRUCTIONS
•The engine should be switched off when moving over ground that is not to be mowed. For example, gravel paths, stone, shingle, asphalt, etc.
The brake handle must never be permanently anchored in handle when the machine is running.
Follow the instructions above, but do not use a lawn mower in a situation where you cannot call for help in case of an accident.
Basic mowing technique
WARNING! Make sure that your hands and
!feet do not come near the cutting attachment when the engine is running.
General
•Mowing slopes can be dangerous. Do not use the lawn mower on very steep slopes.
•The lawn mower should not be used on inclines greater than 30 degrees.
•On sloping ground you should work along the slope. It is much easier to work along a slope than it is to work up and down it.
•Branches, twigs, stones, etc. should be removed from the lawn before you start to mow.
•Never lift up the lawn mower or carry it around when the engine is running. If you must lift the lawn mower, first switch off the engine and disconnect the ignition lead from the spark plug.
•Make sure the cutter does not hit foreign objects such as stones, roots or the like. This can make the cutter dull and bend the engine shaft. A bent axle gives imbalance and heavy vibration, which results in a great risk of the cutter becoming loose.
•If any foreign object is hit or if vibrations occur stop the machine immediately. Disconnect the HT lead from the spark plug. Check that the machine is not damaged.
Repair any damage.
•Never mow more than 1/3 of the length of the grass. This especially applies during dry periods. Mow first with the cutting height set high. Then check the result and lower to an appropriate height. If the grass is really long, drive slowly and mow twice if necessary.
•Never run with the machine when it is running.You should always walk with the lawn mower.
•Use extreme caution when reversing or pulling the lawnmower towards you.
Cutting height
Shut down the engine before changing the cutting height.
The cutting height can be adjusted in five different steps, mm.
Do not set the cutting height too low as there is a risk that the cutters might hit slopes with unevenness.
Adjusting the cutting height
Shut down the engine before changing the cutting height.
Set the cutting height using the cutting height control on the
•To lower the cutting height move the lever to the right and then forward.
•To raise the cutting height move the lever to the right and then backward.
Do not set the cutting height too low as there is a risk that the cutters might hit slopes with unevenness.
80 – English