Husqvarna YTH1848XPT owner manual ADD Gasoline, To Start Engine See Fig, Purge Transmission

Page 12

OPERATION

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast position. This may re- quire an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up.This can be done during the engine warm up period.

•The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run-

ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

•Place tractor safely on level surface with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. Dis- engage parking brake

•Depress forward drive pedal to full forward position, hold for five (5) seconds and release pedal. Depress reverse drive pedal to full reverse position, hold for five

(5) seconds and release pedal. Repeat this procedure three (3) times.

NOTE: During this procedure there will be no movement of drive wheels. The air is being removed from hydraulic drive system.

•Shut- off engine and set parking brake.

•Engage transmission by placing freewheel control in engaged position (See “TO TRANSPORT” in this sec- tion of manual).

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents YTH1848XPT Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Assembly Tools Required for AssemblyUnassembled Parts To Remove Tractor from CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance Before Each USEBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install Mower See FigsTractor See Fig To Remove MowerFirst Install ANTI-SWAY BAR S To Level Mower To Replace Mower Blade Drive Belt See Fig Mower Drive Belt RemovalMower Drive Belt Installation Belt InstallationTo Replace Motion Drive Belt See Fig To Check BrakeTo Start Engine with a Weak Battery See Fig Replacing Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Service Notes Schematic Tractor Model NO. YTH1848XPT 96043000700, Product no 43Electrical KEY Part Description Chassis Tractor Model NO. YTH1848XPT 96043000700, Product no 43 Drive Tractor Model NO. YTH1848XPT 96043000700, Product no 43 Steering Assembly Spark Arrester KIT EngineSeat Assembly Decals Wheels and TiresMower Deck 22 532 17 44-93 Stripper Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement

YTH1848XPT specifications

The Husqvarna YTH1848XPT is a powerful and versatile lawn tractor designed to meet the needs of homeowners with expansive lawns or those who demand more from their mowing equipment. This model combines innovative features, advanced technology, and user-friendly characteristics to provide an exceptional mowing experience.

One of the standout features of the YTH1848XPT is its robust 18.5 HP Briggs & Stratton engine. This powerful engine ensures reliable performance, enabling the mower to tackle various terrain types efficiently. The engine is paired with a smooth hydrostatic transmission, allowing for easy speed adjustments and seamless operation without the need for shifting gears. This can significantly reduce the effort required for mowing and increase overall productivity.

The cutting deck on the YTH1848XPT is 48 inches wide, allowing for a quicker mowing time over larger areas. It is built for durability and features an efficient design that provides a clean, even cut. The deck can easily be adjusted to multiple cutting heights, ranging from 1 to 4 inches, allowing users to customize their mowing height based on their lawn’s specific requirements.

Further adding to its functionality, the YTH1848XPT is equipped with a robust chassis that enhances stability and handling. Its tight turning radius makes maneuvering around obstacles like trees and flower beds hassle-free. Additionally, the ergonomically designed seat provides comfort during extended mowing sessions, reducing operator fatigue.

Technologically, the YTH1848XPT comes with several advanced features that improve the mowing experience. The intuitive dashboard provides essential information at a glance, including fuel level, engine temperature, and service reminders. The mower also features a user-friendly cutting deck washout port, making deck cleaning simple and helping to maintain optimal performance.

Overall, the Husqvarna YTH1848XPT stands out as an efficient and user-friendly lawn tractor, suitable for homeowners who want to maintain their lawns with precision and ease. Its combination of powerful performance, advanced features, and thoughtful design ensures that it remains a reliable choice for those looking to invest in quality lawn care equipment. Whether tackling a small yard or expansive property, the YTH1848XPT delivers results that meet high expectations.
Top Page Image Contents