Husqvarna 33RJ manual Assembly, Fitting the J-handle, Assembling the cutting equipment

Page 13

ASSEMBLY

Fitting the J-handle

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle.

•Fit the nut, knob and screw. Do not overtighten.

•Attach the J-handle to the loop handle using the three screws, as shown.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

WARNING! Only grass blades/grass cutters

! or trimmer heads/plastic blades may be used when the J-handle is fitted. Saw blades must never be used with the J- handle.

Assembling the cutting equipment

WARNING!

! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting attachment

! without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting the guard extension

CAUTION! The guard extension shall always be fitted when using the trimmer head/plastic blades and combination guard. The guard extension shall always be removed when using the grass blade and combination guard.

Enter the guard extension guide in the slot of the combination guard. Then click the guard extension into position on the guard with the four quick-fasteners.

The guard extension is removed easily using the spark plug spanner, see illustration.

English – 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 333RJ 335RJX-series Symbols KEY to SymbolsStarting instructions Contents TWC Dear customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system Muffler Locking nut Cutting equipmentCutting equipment Trimmer head Sharpening grass cutters and grass bladesGeneral rules Fitting the J-handle AssemblyAssembling the cutting equipment Fitting the guard extensionEnsure that the guard extension is removed Fuel Handling Fuel safetyFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingAround your hand StoppingWorking Techniques Basic safety rulesGeneral working instructions Basic working techniques Grass clearing using a grass bladeGrass trimming with a trimmer head TrimmingSweeping CuttingCarburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TMuffler High speed jet HCooling system Cleaning the air filterBevel gear Air filterOiling the air filter Spark plugMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataYour Warranty Rights and Obligations Emission Warranty Parts List Page S35 25 m T35, T35x T45, T45x Page 1150887-95
Top Page Image Contents