Husqvarna 33RJ manual Cooling system, Bevel gear, Air filter, Cleaning the air filter

Page 24

MAINTENANCE

frequently blocked, this can be a sign that the performance of the catalytic converter is impaired. Contact your dealer to inspect the muffler. A blocked screen will cause the machine to overheat and result in damage to the cylinder and piston.

CAUTION! Never use a machine with a defective muffler.

WARNING! Mufflers fitted with catalytic

! converters get very hot during use and remain so for some time after stopping. This also applies at idle speed. Contact can result in burns to the skin. Remember the risk of fire!

Cooling system

To keep the working temperature as low as possible the machine is equipped with a cooling system.

3 2

1

The cooling system consists of:

1Air intake on the starter.

2Cooling fins on the cylinder.

3Cylinder cover (directs cold air over the cylinder).

Clean the cooling system with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the machine overheating which causes damage to the piston and cylinder.

Bevel gear

The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three-quarters full with grease. Use HUSQVARNA special grease.

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter

must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

24 – English

Image 24
Contents 333RJ 335RJX-series KEY to Symbols SymbolsStarting instructions Contents TWC Introduction Dear customerWhat is WHAT? What is what on the clearing saw?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system Muffler Cutting equipment Locking nutCutting equipment Sharpening grass cutters and grass blades Trimmer headGeneral rules Assembly Fitting the J-handleAssembling the cutting equipment Fitting the guard extensionEnsure that the guard extension is removed Fuel safety Fuel HandlingFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Around your handBasic safety rules Working TechniquesGeneral working instructions Grass clearing using a grass blade Basic working techniquesGrass trimming with a trimmer head TrimmingCutting SweepingMaintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorMuffler High speed jet HCleaning the air filter Cooling systemBevel gear Air filterSpark plug Oiling the air filterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataYour Warranty Rights and Obligations Emission Warranty Parts List Page S35 25 m T35, T35x T45, T45x Page 1150887-95