Husqvarna 33RJ manual Spark plug, Oiling the air filter

Page 25

MAINTENANCE

Oiling the air filter

Always use special filter oil. Filter oil contains a solvent to make it spread evenly through the filter.You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

Spark plug

The spark plug condition is influenced by:

Incorrect carburetor adjustment.

An incorrect fuel mixture (too much or incorrect type of oil).

A dirty air filter.

These factors cause deposits on the spark plug electrodes, which may result in operating problems and starting difficulties.

If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0.020 inch (0.5 mm).The spark plug should be replaced after about a month in operation or earlier if necessary.

CAUTION! Always use the recommended spark plug type!

Use of the wrong spark plug can damage the piston/cylinder.

Check that the spark plug is fitted with a suppressor.

Note: Use only HUSQVARNA replacement parts. Use of other brands of replacement parts can cause damage to your unit or injury to the operator or others. Your warranty does not cover damage or liability caused by the use of accessories and/or attachments not specifically recommended by HUSQVARNA.

English 25

Image 25
Contents 333RJ 335RJX-series Symbols KEY to SymbolsStarting instructions Contents TWC Dear customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system Muffler Locking nut Cutting equipmentCutting equipment Trimmer head Sharpening grass cutters and grass bladesGeneral rules Fitting the J-handle AssemblyAssembling the cutting equipment Fitting the guard extensionEnsure that the guard extension is removed Fuel Handling Fuel safetyFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingAround your hand StoppingWorking Techniques Basic safety rulesGeneral working instructions Basic working techniques Grass clearing using a grass bladeGrass trimming with a trimmer head TrimmingSweeping CuttingCarburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TMuffler High speed jet HCooling system Cleaning the air filterBevel gear Air filterOiling the air filter Spark plugMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataYour Warranty Rights and Obligations Emission Warranty Parts List Page S35 25 m T35, T35x T45, T45x Page 1150887-95