Husqvarna 33RJ manual Ensure that the guard extension is removed

Page 14

ASSEMBLY

Fitting a blade guard, grass blade and grass cutter

G

F

E

D

B

AC

Fitting other guards and cutting attachments

•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. CAUTION! Ensure that the guard extension is ﬁtted.

Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.

L

A

• Hook the blade guard/combination guard (A) onto the

ﬁtting on the shaft and secure with the bolt. CAUTION!

Ensure that the guard extension is removed.

Use the recommended blade guard. See the Technical

data section.

M

A

C

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive disc

aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Place the blade (D), support cup (E) and support ﬂange

(F) on the output shaft.

• Fit the nut (G). The nut must be tightened to a torque of

35-50 Nm (3.5-5 kpm). Use the socket spanner in the

tool kit. Hold the shaft of the spanner as close to the

blade guard as possible. To tighten the nut, turn the

spanner in the opposite direction to the direction of

rotation (Caution! left-hand thread).

•Fit the drive disc (B) on the output shaft.

H

BA

C

M L

• Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

H

H

•To dismantle, follow the instructions in the reverse order.

14 – English

Image 14

Contents 333RJ 335RJX-series Starting instructions KEY to SymbolsSymbols Contents TWC Introduction Dear customerWhat is WHAT? What is what on the clearing saw?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Mufﬂer Cutting equipment Cutting equipmentLocking nut General rules Sharpening grass cutters and grass bladesTrimmer head Assembling the cutting equipment AssemblyFitting the J-handle Fitting the guard extensionEnsure that the guard extension is removed Fuel Fuel safetyFuel Handling Fueling MixingStarting and stopping Starting and StoppingCheck before starting StartingStopping Around your handGeneral working instructions Basic safety rulesWorking Techniques Grass trimming with a trimmer head Grass clearing using a grass bladeBasic working techniques TrimmingCutting SweepingMaintenance CarburetorMufﬂer Fine adjustment of the idle speed TCorrectly adjusted carburetor High speed jet HBevel gear Cleaning the air ﬁlterCooling system Air ﬁlterSpark plug Oiling the air ﬁlterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataYour Warranty Rights and Obligations Emission Warranty Parts List Page S35 25 m T35, T35x T45, T45x Page 1150887-95