Husqvarna LTH18538 owner manual Transaxle Motion Control Lever, To Remove Wheel See Fig

Page 23

SERVICE AND

TRANSAXLE MOTION CONTROL LEVER

NEUTRAL ADJUSTMENT (See Fig. 35)

The motion control lever has been preset at the factory and adjustment should not be necessary.

•Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.

•Start engine and move motion control lever until tractor does not move forward or backward.

•Hold motion control lever in that position andturn engine off.

•While holding motion control lever in place, loosen the adjustment bolt.

•Move motion control lever to the neutral (lock gate) position.

•Tighten adjustment bolt securely.

NOTE: Ifadditional clearance is neededto getto adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral

position, follow these steps:

•Loosen the adjustment bolt.

•Move the motion control lever 1/4" to 1/2" in the direc- tion it is trying to creep.

•Tighten adjustment bolt securely.

•Start engine and test.

•Iftractor still creeps, repeat above steps until satisfied.

MOTION CONTROL

NEUTRAL

 

 

LOCK

 

GATE

,

ADJ USTMENT

,,,"

BOLT

Fig. 35

TO REMOVE WHEEL (See Fig. 36)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

 

RETAINING

WASHERS

 

 

 

RING

 

AXLE

 

SQUARE

KEY (REAR

i

WHEEL

ONLY)

 

ADJUSTMENTS

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your

local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straightforward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE=IN/CAMBER

Your new tractor front wheel toe-in and camber isset at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO START ENGINE WITH A WEAK BATTERY

(See Fig. 37)

WARNING: Lead=acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If "jumper cables" are used for emergency starting, follow this procedure:

iMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERYTO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACKcable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

WEAK

OR

FULLY CHARGED

DEAD

BATTERY

BATTERY

Fig. 37

Fig. 36

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents 532 43 62-86 Rev Ft. Slope Operation Safe Operation Practices for Ride=On MowersGeneral Operation Safe Handling of Gasoline RulesSafe Operation Practices IV. TowingContents Steering Wheel Unassembled PartsBefore Removing Tractor from AssemblyTools Required for Assembly To Remove Tractor from CartonTo Adjust Seat See Fig INSTALL Seat See FigsTo Install Hood Scoop See Fig Check for Proper Position of ALL Belts JchecklistCheck TiRE Pressure Check Deck LevelnessOperation 1 e -IbReverse Operation System ROS on POSI= Know Your TractorStopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Stop Mower Blades To Adjust Mower Cutting HeightTo Adjust Gauge Wheels See Fig To Operate MowerTowing Carts & Other Attachments Before Starting the EngineAutomatic Transmission Warm UP Mowing TipsPurge Transmission Schedule MaintenanceChart General RecommendationsBlade Removal See Fig BatteryTractor Blade CareLubrication Transaxle MaintenanceClean AIR Screen Transaxle Pump FluidSpark Plugs CleaningEngine Cooling System See Fig MufflerTo Remove Mower See Fig Service and AdjustmentsTo iNSTALL Mower See Adjustments ServiceTo Level Mower AI L- WTo Check Brake Belt InstallationTo Replace Mower Blade Drive Belt To Replace Motion Drive BeltSee Fig To Adjust Steering Wheel AlignmentTransaxle Motion Control Lever To Remove Wheel See FigEngine TransmissionCylinders OtherFuel System Engine OILTroubleshooting If so equipped KEY Part DecalsWheels TiresQD D SchematicTractor -- Model Number LTH18538 Electrical Electrical Chassis Tractor --MODEL Number LTH18538KEY Part Description KEYDrive Drive Optional Equipment Tractor -- Model Number LTH18538Engine Engine Steering Assembly KEY Part NO. no Mower Deck KEY Part Mower Deck1089 100 101 Mower LiftSeat Assembly Tufftorq Transaxle Model NO. K46BA LO9DESCRiPTiON Briggs Engine Model Number 31 N707, Type Number 1374-B1 132gREPLACEMENTLO4O,,,%. ,, ,o5,+ KEY Part NO. no Use 692011 Rod-Push Exhaust With Liquid Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationHusqvarna HOW To Obtain Service Consumer Wheeled Warranty Chart Tic Wrs Service Otes Husqvarna

LTH18538 specifications

The Husqvarna LTH18538 is a robust and versatile riding lawn mower designed for homeowners seeking a reliable solution for lawn care. This mower is equipped with a powerful 18.5 horsepower Kohler engine, which provides ample power to tackle different terrains and ensures a reliable start every time. It features a hydrostatic transmission that offers smooth and effortless operation, allowing users to experience a more enjoyable mowing experience without the need for gear shifting.

One of the standout features of the LTH18538 is its 38-inch cutting deck. The cutting deck is made from durable materials and ensures a clean and precise cut, contributing to a healthier lawn. The mower also offers a variety of cutting heights, adjustable from 1 to 4 inches, allowing users to customize the grass height based on their preferences and lawn conditions. The design of the cutting deck enhances maneuverability, making it easier to navigate around trees and garden beds.

Comfort and convenience are key considerations in the design of the Husqvarna LTH18538. It comes with an ergonomic seat with adjustable armrests, ensuring that users can mow for extended periods without discomfort. The steering wheel is positioned for easy access, and the controls are intuitively laid out, enhancing the overall user experience. The large rear tires provide excellent traction, even on uneven ground, which ensures that the mower can handle inclines and rough patches effectively.

Technologically, the LTH18538 is equipped with features that enhance performance and ease of maintenance. The mower has a built-in electric blade engagement system, allowing users to start the blades quickly and efficiently. An easy-to-access battery, along with a convenient air filter, makes routine maintenance hassle-free. Additionally, the mower's compact size allows for easy storage in garages or sheds, making it an ideal choice for those with limited space.

Overall, the Husqvarna LTH18538 combines power, convenience, and innovative technology, making it a standout model in the riding mower segment. Suitable for small to medium-sized lawns, this model strikes a perfect balance between performance and user comfort, ensuring a well-maintained lawn with minimal effort. Whether it's for regular mowing or seasonal upkeep, the LTH18538 is an excellent addition to any home gardening toolkit.
Top Page Image Contents