Husqvarna LTH18538 Tools Required for Assembly, To Remove Tractor from Carton, Skid

Page 6

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

5/16" wrench

Utility knife

(2)

7/16" wrenches

Tire pressure gauge

(2)

1/2" wrenches

Pliers

(1)

9/16" wrench

 

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton.

•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM

SKID

TO INSTALL STEERING WHEEL (See Fig. 1)

ASSEMBLE EXTENSION SHAFT AND BOOT

•Slide extension shaft onto lower steering shaft.

•Place tabs of steering boot over tab slots in dash and push down to secure.

INSTALL STEERING WHEEL

•Position front wheels of the tractor so they are pointing straight forward.

•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.

Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.

•Assemble large flat washer, lock washer, hex bolt and tighten securely.

•Snap steering wheel insert into center of steering wheel.

•Remove protective materials from tractor hood and grill.

iMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO

ROLL OFF SKID.

/

"'-7°

- BOLT

!

 

.;f:--2-_

 

?J

/

,',

 

 

 

 

\

LARGE FLAT

 

WASHER

 

"

' ' "

WASHERJ

 

 

 

 

zi"

 

_\x

STEERING

 

tF -

_;

x _WHEEL

 

 

 

 

t_

 

 

 

_--_STEERING BOOT

\/

ADAPTER

LOWEREXTENSION

STEERINGSHAFT

SHAFT _ -

Fig. 1

TO CHECK BATTERY (See Fig. 2)

Lift seat to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

•For battery and battery cable installation see "RE- PLACING BATTERY" inthe "Service and Adjustments" section in this manual.

LABEL

Fig. 2

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents 532 43 62-86 Rev Safe Operation Practices for Ride=On Mowers General OperationFt. Slope Operation IV. Towing RulesSafe Operation Practices Safe Handling of GasolineContents Unassembled Parts Steering WheelTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor fromINSTALL Seat See Figs To Install Hood Scoop See FigTo Adjust Seat See Fig Check Deck Levelness JchecklistCheck TiRE Pressure Check for Proper Position of ALL Belts1 e -Ib OperationKnow Your Tractor Reverse Operation System ROS on POSI=To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate Mower To Adjust Mower Cutting HeightTo Adjust Gauge Wheels See Fig To Stop Mower BladesBefore Starting the Engine Towing Carts & Other AttachmentsMowing Tips Purge TransmissionAutomatic Transmission Warm UP General Recommendations MaintenanceChart ScheduleBlade Care BatteryTractor Blade Removal See FigTransaxle Pump Fluid Transaxle MaintenanceClean AIR Screen LubricationMuffler CleaningEngine Cooling System See Fig Spark PlugsService and Adjustments To iNSTALL Mower SeeTo Remove Mower See Fig Service AdjustmentsAI L- W To Level MowerTo Replace Motion Drive Belt Belt InstallationTo Replace Mower Blade Drive Belt To Check BrakeTo Remove Wheel See Fig To Adjust Steering Wheel AlignmentTransaxle Motion Control Lever See FigTransmission EngineEngine OIL OtherFuel System CylindersTroubleshooting If so equipped Tires DecalsWheels KEY PartSchematic QD DTractor -- Model Number LTH18538 Electrical Electrical Tractor --MODEL Number LTH18538 ChassisKEY KEY Part DescriptionDrive Drive Tractor -- Model Number LTH18538 EngineOptional Equipment Engine Steering Assembly KEY Part NO. no Mower Deck Mower Deck KEY PartMower Lift 1089 100 101Seat Assembly LO9 Tufftorq Transaxle Model NO. K46BADESCRiPTiON 132gREPLACEMENT Briggs Engine Model Number 31 N707, Type Number 1374-B1LO4O,,,%. ,, ,o5,+ KEY Part NO. no Use 692011 Rod-Push Exhaust With Liquid Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXHusqvarna HOW To Obtain Service Consumer Wheeled Warranty Chart Tic Wrs Service Otes Husqvarna

LTH18538 specifications

The Husqvarna LTH18538 is a robust and versatile riding lawn mower designed for homeowners seeking a reliable solution for lawn care. This mower is equipped with a powerful 18.5 horsepower Kohler engine, which provides ample power to tackle different terrains and ensures a reliable start every time. It features a hydrostatic transmission that offers smooth and effortless operation, allowing users to experience a more enjoyable mowing experience without the need for gear shifting.

One of the standout features of the LTH18538 is its 38-inch cutting deck. The cutting deck is made from durable materials and ensures a clean and precise cut, contributing to a healthier lawn. The mower also offers a variety of cutting heights, adjustable from 1 to 4 inches, allowing users to customize the grass height based on their preferences and lawn conditions. The design of the cutting deck enhances maneuverability, making it easier to navigate around trees and garden beds.

Comfort and convenience are key considerations in the design of the Husqvarna LTH18538. It comes with an ergonomic seat with adjustable armrests, ensuring that users can mow for extended periods without discomfort. The steering wheel is positioned for easy access, and the controls are intuitively laid out, enhancing the overall user experience. The large rear tires provide excellent traction, even on uneven ground, which ensures that the mower can handle inclines and rough patches effectively.

Technologically, the LTH18538 is equipped with features that enhance performance and ease of maintenance. The mower has a built-in electric blade engagement system, allowing users to start the blades quickly and efficiently. An easy-to-access battery, along with a convenient air filter, makes routine maintenance hassle-free. Additionally, the mower's compact size allows for easy storage in garages or sheds, making it an ideal choice for those with limited space.

Overall, the Husqvarna LTH18538 combines power, convenience, and innovative technology, making it a standout model in the riding mower segment. Suitable for small to medium-sized lawns, this model strikes a perfect balance between performance and user comfort, ensuring a well-maintained lawn with minimal effort. Whether it's for regular mowing or seasonal upkeep, the LTH18538 is an excellent addition to any home gardening toolkit.
Top Page Image Contents