Husqvarna LT120 Transaxle Shifter Linkage and AD- Justment See Figs, Front Wheel TOE-IN/CAMBER

Page 21

SERVICE AND ADJUSTMENTS

TRANSAXLE SHIFTER LINKAGE AND AD- JUSTMENT (See Figs. 26 and 27)

The transaxle should be in neutral when the gear shift lever is in the neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:

•Make sure transaxle is in neutral (N).

•Loosen two locknuts on tie rod.

•Turn center rod until gearshift lever falls into neutral lock gate on fender console.

•Tighten locknuts securely.

GEARSHIFT LEVER

NEUTRAL

LOCK GATE

FIG. 26

LOCKNUT

CENTER ROD

TIRE ROD

TRANSAXLE

FIG. 27

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 28)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY

(REAR WHEEL ONLY)

FIG. 28

TO START ENGINE WITH A WEAK BATTERY (See Fig. 29)

CAUTION: Lead-acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE

(+)terminal of each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGA- TIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents LT 1 2 Safe Operation Practices for Ride-On Mowers IV. ServiceGeneral Operation II. Slope OperationProduct Specifications Customer ResponsibilitiesModel Number LT120 Serial Table of Contents Contents of Hardware Pack Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Mulcher Plate See Figs Install Seat See FigCheck Tire Pressure To Convert to Bagging or DischargingCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Before Starting the EngineTo Transport ADD GasolineMulching Mowing Tips Mowing TipsCustomer Responsibilities Lubrication ChartGeneral Recommendations Before Each USETractor BatteryBrake Operation TiresBelts EngineTransaxle Cooling LubricationCleaning MufflerSpark Plugs Service and Adjustments To Install Mower See FigTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingBelt Installation To Adjust Brake See FigTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel AlignmentTransaxle Shifter Linkage and AD- Justment See Figs Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable See Fig To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb Interlocks and RelaysPreliminary Setting To Adjust Carburetor See FigFinal Setting Acceleration TestOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsOFF Slope CUT This OUT Dotted Is aLimited Warranty Warranty StatementSchematic Ignition SwitchWiring Insulated Clips Electrical KEY Part NO. NO. Description Chassis and Enclosures Repair Parts Drive KEY Part NO. no Description Steering Assembly KEY Part Description NO. no Seat Assembly Decals Wheels & TiresKEY Part Description Engine Repair Parts Mower Deck Repair Parts Mower Lift Repair Parts Peerless Transaxle Model Number 930-054A Part Description Rev 10.07.96 Kfsw

LT120 specifications

The Husqvarna LT120 represents a remarkable balance of performance, durability, and user-friendly design, making it an ideal choice for homeowners looking to maintain their lawns efficiently. This riding lawn mower is engineered with a focus on comfort and functionality, ensuring that each mowing session is as productive as possible.

One of the most notable features of the LT120 is its powerful 17.5 HP Briggs & Stratton engine. This reliable engine ensures that the mower can tackle various terrains effortlessly, offering consistent power and performance even in challenging conditions. The efficient engine design also translates into lower fuel consumption, making it a cost-effective solution for lawn maintenance.

The LT120 boasts a 42-inch cutting deck, which allows for considerable coverage in a single pass. The deck is constructed from stamped steel, ensuring durability and longevity while providing a clean, precise cut. Additionally, the cutting height can be easily adjusted to six different settings, ranging from one to four inches, giving users the flexibility to achieve their desired lawn height.

For user comfort, the LT120 features an ergonomic steering wheel and a comfortable, adjustable seat. These enhancements make it easier for users to navigate their lawns for extended periods without discomfort. The mower's compact design also contributes to its maneuverability, allowing it to reach tight spaces and corners that larger models might struggle with.

Another impressive aspect of the Husqvarna LT120 is its easy-to-use hydrostatic transmission. This technology allows for smooth and seamless speed adjustments without the need for manual gear shifting. Users can simply press the pedals to change speed and direction, making the mowing experience more intuitive and less physically demanding.

Safety is paramount in the design of the LT120. It is equipped with features such as an automatic blade engagement system, which ensures that the blades only engage when the operator is seated. Additionally, the machine includes a reverse operating system that allows users to mow in reverse safely.

Overall, the Husqvarna LT120 combines power, efficiency, and comfort, making it a superb choice for residential lawn care. With its quality construction and thoughtful design features, it provides an exceptional mowing experience, helping homeowners achieve a well-maintained lawn with ease. Whether tackling small or medium-sized lawns, the LT120 ensures that lawn care is a task that can be handled with confidence and satisfaction.
Top Page Image Contents