Husqvarna 2042 LS (CA) Before Starting the Engine, Service REMINDER/HOUR Meter, ADD Gasoline

Page 13

OPERATION

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

12

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

Page 12 Page 14
Image 13
Page 12 Page 14
Contents LS CA Page Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Unassembled Parts AssemblyTo Remove Tractor from Carton Unpack CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking BRAKESee Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigReverse Operation System ROS Using the Reverse Operation SystemTo Operate on Hills To Transport See FigsBefore Starting the Engine Service REMINDER/HOUR MeterCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsLubrication Chart MaintenanceBrake Operation TractorTires Blade CareEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Service and Adjustments To Level Mower To Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigTo Check Brake To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points Engine dies when SCH12 SchematicElectrical KEY Part Description Chassis Tractor - Model Number 2042LS 96043004800, Product no 43 Drive Tractor - Model Number 2042LS 96043004800, Product no 43 Engine Spark Arrester KIT28 90 Engine Power Rating Information Steering Assembly 532 41 Wheel, Steering 532 18 532 40 Seat Seat AssemblyWheels and Tires Decals116 190 145118 188 189 6188Mower Deck 100 Mower LiftSuggested Guide for Sighting Slopes for Safe Operation 532 41 88-19 12-12-07 SBW Warranty Statement

2042 LS (CA) specifications

The Husqvarna 2042 LS (CA) is a lawnmower designed for both efficiency and user convenience, making it an ideal choice for homeowners looking to maintain a pristine lawn. This model combines powerful performance with innovative technology, ensuring a superior mowing experience.

One of the standout features of the Husqvarna 2042 LS is its impressive cutting deck. With a 42-inch cutting width, it allows for the swift trimming of lawns while maintaining the ability to navigate various terrains with ease. The cutting deck is designed for optimal airflow, enhancing grass clipping distribution for a neater finish. The mower also comes equipped with a robust steel chassis that promotes durability and longevity.

Powering the Husqvarna 2042 LS is a reliable and potent engine, providing the necessary torque to tackle different grass types and terrain obstacles. This ensures that the mower can effortlessly handle thicker grass without stalling, catering to diverse lawn conditions. The intuitive starting system allows for easy ignition, so users can quickly get to work without frustration.

Another notable characteristic is the advanced cutting height adjustment system. This feature allows users to easily select their preferred cutting height, enhancing flexibility for different seasons or grass types. Whether one wants a short trim during the summer or a slightly longer cut in the spring, the 2042 LS accommodates these needs with multiple height settings.

User comfort is prioritized with the ergonomic design of the mower. The handles are adjustable and designed to reduce fatigue during extended use. Additionally, the tractor-style layout provides better visibility, ensuring that users can easily monitor their mowing path.

The Husqvarna 2042 LS stands out due to its commitment to technology as well. The mower incorporates features such as a dashboard display that provides important information like fuel levels and service reminders, ensuring that users are always informed about machine performance.

Fuel efficiency is another hallmark of this lawnmower, minimizing trips to the gas station and maximizing cutting time. Combined with low emissions, the Husqvarna 2042 LS (CA) is an environmentally friendly option.

In conclusion, the Husqvarna 2042 LS (CA) is a powerful, versatile lawnmower that combines efficiency, user-friendly features, and innovative technology. Its durable design, advanced cutting systems, and comfort-oriented attributes make it an excellent investment for any homeowner looking to enhance their lawn care experience.
Top Page Image Contents