Husqvarna 2042 LS (CA) Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 17)

•Place attachment clutch in “DISENGAGED” position.

•Lower attachment lift lever to its lowest position.

•Roll belt off engine pulley (M) and belt keepers (G).

•Remove retainer spring (K), slide collar (L) off and push housing guide (P) out of bracket.

•Remove clutch cable spring (Q) from idler arm (R).

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis pin (B) and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

CAUTION: AFTER REAR LIFT LINKS

ARE DISCONNECTED, THE ATTACH-

MENT LIFT LEVER WILL BE SPRING

LOADED. HAVE A TIGHT GRIP ON LIFT

LEVER WHEN CHANGING POSITION

OF THE LEVER.

•Slide mower out from under right side of tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINK (E) AND REAR LIFT LIKS

(C)FROM TRACTOR AND HOOK THE CLUTCH SPRING

(Q)INTO THE CABLE GUIDE ON FRONT EDGE OF LOWER DASH.

TO INSTALL MOWER (See Fig. 17–21)

Be sure tractor is on level surface and engage parking brake.

•Lower attachment lift lever to it's lowest position.

CAUTION: LIFT LEVER IS SPRING

LOADED. HAVE A TIGHT GRIP ON

LIFT LEVER, LOWER IT SLOWLY AND

ENGAGE IN LOWEST POSITION.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

 

M

F

G

 

R

 

G

 

 

Q

A

 

 

E

 

 

P

B

C

K

D

 

L

FIG. 17

 

 

18

Page 18 Page 20
Image 19
Page 18 Page 20
Contents LS CA Page II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIII. Children ServiceIV. Towing Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Transport See Figs Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelPurge Transmission Mowing TipsLubrication Chart MaintenanceBlade Care TractorBrake Operation TiresEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Service and Adjustments To Level Mower To Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when SCH12 SchematicElectrical KEY Part Description Chassis Tractor - Model Number 2042LS 96043004800, Product no 43 Drive Tractor - Model Number 2042LS 96043004800, Product no 43 Engine Spark Arrester KIT28 90 Engine Power Rating Information Steering Assembly 532 41 Wheel, Steering 532 18 532 40 Seat Seat AssemblyWheels and Tires Decals188 189 6188 145116 190 118Mower Deck 100 Mower LiftSuggested Guide for Sighting Slopes for Safe Operation 532 41 88-19 12-12-07 SBW Warranty Statement

2042 LS (CA) specifications

The Husqvarna 2042 LS (CA) is a lawnmower designed for both efficiency and user convenience, making it an ideal choice for homeowners looking to maintain a pristine lawn. This model combines powerful performance with innovative technology, ensuring a superior mowing experience.

One of the standout features of the Husqvarna 2042 LS is its impressive cutting deck. With a 42-inch cutting width, it allows for the swift trimming of lawns while maintaining the ability to navigate various terrains with ease. The cutting deck is designed for optimal airflow, enhancing grass clipping distribution for a neater finish. The mower also comes equipped with a robust steel chassis that promotes durability and longevity.

Powering the Husqvarna 2042 LS is a reliable and potent engine, providing the necessary torque to tackle different grass types and terrain obstacles. This ensures that the mower can effortlessly handle thicker grass without stalling, catering to diverse lawn conditions. The intuitive starting system allows for easy ignition, so users can quickly get to work without frustration.

Another notable characteristic is the advanced cutting height adjustment system. This feature allows users to easily select their preferred cutting height, enhancing flexibility for different seasons or grass types. Whether one wants a short trim during the summer or a slightly longer cut in the spring, the 2042 LS accommodates these needs with multiple height settings.

User comfort is prioritized with the ergonomic design of the mower. The handles are adjustable and designed to reduce fatigue during extended use. Additionally, the tractor-style layout provides better visibility, ensuring that users can easily monitor their mowing path.

The Husqvarna 2042 LS stands out due to its commitment to technology as well. The mower incorporates features such as a dashboard display that provides important information like fuel levels and service reminders, ensuring that users are always informed about machine performance.

Fuel efficiency is another hallmark of this lawnmower, minimizing trips to the gas station and maximizing cutting time. Combined with low emissions, the Husqvarna 2042 LS (CA) is an environmentally friendly option.

In conclusion, the Husqvarna 2042 LS (CA) is a powerful, versatile lawnmower that combines efficiency, user-friendly features, and innovative technology. Its durable design, advanced cutting systems, and comfort-oriented attributes make it an excellent investment for any homeowner looking to enhance their lawn care experience.
Top Page Image Contents