Husqvarna HU800AWD Maintenance Guide: Oil Capacity and More

MAINTENANCE

•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with balancer.)

NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not.

•Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.

TO CHANGE ENGINE OIL (See Figs. 15 & 16)

NOTE: Before tipping lawn mower to drain oil, empty fuel tank by running engine until fuel tank is empty.

1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

2.Remove oil ﬁ ll cap/dipstick; lay aside on a clean sur- face.

3.Tip lawn mower on its side as shown and drain oil into a suitable container. Rock lawn mower back and forth to remove any oil trapped inside of engine.

GRASS CATCHER

•The grass catcher may be hosed with water, but must be dry when used.

•Check your grass catcher often for damage or dete- rioration. Through normal use it will wear. If catcher needs replacing, replace only with approved replace- ment catcher shown in the Repair Parts section of this manual. Give the lawn mower model number when ordering.

GEAR CASES

•To keep your drive system working properly, the gear cases and area around the drive should be kept clean and free of trash build-up. Clean under the drive cover twice a season.

•The gear cases are ﬁlled with lubricant to the proper level at the factory. The only time the lubricant needs atten- tion is if service has been performed on the gear case.

ENGINE

LUBRICATION

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the custom- ers expense, may be performed by any non-road engine repair establishment or individual. Warranty repairs must be performed by an authorized engine manufacturer’s service outlet.

LUBRICATION

Use only high quality detergent oil rated with API service classiﬁcation SG–SL. Select the oil's SAE viscosity grade according to your expected operating temperature.

CONTAINER

FIG. 15

4.Wipe off any spilled oil from lawn mower or side of engine.

5.Fill engine with oil. Slowly pour oil down the oil ﬁ ll spout into the engine.

6.Wait one minute to allow oil to settle. Use guage on oil ﬁ ll cap/dipstick for checking level. Insert dipstick into the tube and rest the oil ﬁ ll cap on the tube. DO NOT thread the cap into the tube when taking reading.

OIL FILL CAP /

DIPSTICK

UPPER

MARK

LOWER MARK

NOTE: Multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, and you should check your engine oil level frequently to avoid possible engine damage from running low on oil.

Change the oil after every 25 hours of operation or at least once a year if the lawn mower is not used for 25 hours in one year.

Check the crankcase oil level before starting the engine
and after each ﬁ ve (5) hours of continuous use. Tighten oil	12
plug securely each time you check the oil level.	12

FIG. 16

7.Continue adding small amounts of oil and rechecking the dipstick until it reads full. DO NOT overﬁ ll, or engine will smoke on startup.

8.Always be sure to retighten oil ﬁ ll cap/dipstick before starting engine.

9.Reconnect spark plug wire to spark plug.