Husqvarna GTH26K54 To Check Brake, Front Wheel TOE-IN/CAMBER, To Remove Wheel for Repairs See Fig

Page 24

SERVICE AND ADJUSTMENTS

TO CHECK BRAKE

If tractor requires more than fi ve (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

•Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

•Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualifi ed service center.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualifi ed service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 34)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent fl at tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 34

TO START ENGINE WITH A WEAK BATTERY (See Fig. 35)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable fi rst from chassis and then from the fully charged battery.

•RED cable last from both batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WEAK OR DEAD

 

 

FULLY CHARGED

BATTERY

 

 

BATTERY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FIG. 35

REPLACING BATTERY (See Fig. 36)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected fi rst to prevent spark- ing from accidental grounding.

•Lift hood to raised position.

•Disconnect BLACK battery cable (A) then RED battery cable and carefully remove battery from tractor.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents GTH26K54 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Mower Mower Front WheelSlope Sheet KeysAssembly Tools Required for AssemblyTo Remove Tractor from Carton Unpack CartonInstall Mower and Drive Belt First Install ANTI-SWAY BAR S7/16 Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Operate Mower Reverse Operation System ROSService REMINDER/HOUR Meter Before Starting the EngineTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Cleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigService and Adjustments To Install MowerTractor See Fig To Remove MowerTurn nut right Turn nut left To raise mower To Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor Model NO. GTH26K54 96043003100, Product no 43Electrical KEY Part NO. NO. Description Chassis KEY Part Description Drive Transaxle, Hydro Steering Assembly Engine Spark Arrester KITSeat Assembly Decals Wheels and TiresMower Deck Tractor Model NO. GTH26K54 96043003100, Product no 43 Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement

GTH26K54 specifications

The Husqvarna GTH26K54 is a powerful lawn tractor designed for homeowners who seek efficiency and comfort in their lawn maintenance. With its sleek design and robust engineering, this model exemplifies Husqvarna's commitment to quality and innovation.

At the heart of the GTH26K54 is a reliable 26 horsepower Briggs & Stratton engine, offering ample power for tough mowing tasks and ensuring smooth operation across various terrains. The automatic hydrostatic transmission allows for seamless speed adjustments, enhancing maneuverability and providing a user-friendly experience. This feature is particularly beneficial when tackling larger yards or navigating intricate landscapes.

One of the standout characteristics of the GTH26K54 is its 54-inch cutting deck, which is designed to deliver a precise and even cut. The cutting height can be easily adjusted from the operator's seat, with a range of settings to accommodate different grass lengths and conditions. Additionally, the deck comes equipped with a reinforced design, providing durability and resilience against potential damage from obstacles encountered during mowing.

Ergonomics play a significant role in the GTH26K54’s design. The adjustable high-back seat ensures comfort for prolonged use, while the strategically placed controls allow for easy access without sacrificing safety or efficiency. The clear instrumentation panel provides essential information such as fuel levels and engine diagnostics, empowering users to monitor their tractor’s performance effectively.

The GTH26K54 also features advanced technologies, including a durable cast-iron front axle, which enhances stability on uneven terrain and extends the overall lifespan of the tractor. Furthermore, the integrated cutting system improves grass collection for a cleaner finish, while optional mulching kits allow for cleaner lawns and beneficial return of nutrients to the soil.

When it comes to maintenance, Husqvarna has streamlined the process with accessible components, making it easy for owners to perform regular checks and service tasks. The tractor's durable construction minimizes the need for frequent repairs, making it a smart investment for dedicated homeowners.

In summary, the Husqvarna GTH26K54 stands out in the lawn care market as a powerful, versatile, and user-friendly tractor. With its impressive features, advanced technologies, and commitment to comfort, it is an ideal choice for anyone looking to achieve a pristine lawn with minimal hassle.
Top Page Image Contents