Husqvarna GTH26K54 owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 26

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANTTO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTUREWHICH LEADSTO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVERTRACTORWHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents GTH26K54 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Slope Sheet Unassembled PartsMower Mower Front Wheel KeysTo Remove Tractor from Carton AssemblyTools Required for Assembly Unpack CartonInstall Mower and Drive Belt First Install ANTI-SWAY BAR S7/16 Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor StoppingTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig Reverse Operation System ROSTo Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine To Transport See FigsPurge Transmission ADD GasolineTo Start Engine See Fig Automatic Transmission Warm UPMowing Tips General Recommendations MaintenanceMaintenance ScheduleBrake Operation BatteryTractor TiresEngine Spark Plugs CleaningMuffler IN-LINE Fuel Filter See FigTractor See Fig Service and AdjustmentsTo Install Mower To Remove MowerTurn nut right Turn nut left To raise mower To Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Check Brake To Start Engine with a Weak Battery See FigReplacing Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor Model NO. GTH26K54 96043003100, Product no 43Electrical KEY Part NO. NO. Description Chassis KEY Part Description Drive Transaxle, Hydro Steering Assembly Engine Spark Arrester KITSeat Assembly Decals Wheels and TiresMower Deck Tractor Model NO. GTH26K54 96043003100, Product no 43 Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement

GTH26K54 specifications

The Husqvarna GTH26K54 is a powerful lawn tractor designed for homeowners who seek efficiency and comfort in their lawn maintenance. With its sleek design and robust engineering, this model exemplifies Husqvarna's commitment to quality and innovation.

At the heart of the GTH26K54 is a reliable 26 horsepower Briggs & Stratton engine, offering ample power for tough mowing tasks and ensuring smooth operation across various terrains. The automatic hydrostatic transmission allows for seamless speed adjustments, enhancing maneuverability and providing a user-friendly experience. This feature is particularly beneficial when tackling larger yards or navigating intricate landscapes.

One of the standout characteristics of the GTH26K54 is its 54-inch cutting deck, which is designed to deliver a precise and even cut. The cutting height can be easily adjusted from the operator's seat, with a range of settings to accommodate different grass lengths and conditions. Additionally, the deck comes equipped with a reinforced design, providing durability and resilience against potential damage from obstacles encountered during mowing.

Ergonomics play a significant role in the GTH26K54’s design. The adjustable high-back seat ensures comfort for prolonged use, while the strategically placed controls allow for easy access without sacrificing safety or efficiency. The clear instrumentation panel provides essential information such as fuel levels and engine diagnostics, empowering users to monitor their tractor’s performance effectively.

The GTH26K54 also features advanced technologies, including a durable cast-iron front axle, which enhances stability on uneven terrain and extends the overall lifespan of the tractor. Furthermore, the integrated cutting system improves grass collection for a cleaner finish, while optional mulching kits allow for cleaner lawns and beneficial return of nutrients to the soil.

When it comes to maintenance, Husqvarna has streamlined the process with accessible components, making it easy for owners to perform regular checks and service tasks. The tractor's durable construction minimizes the need for frequent repairs, making it a smart investment for dedicated homeowners.

In summary, the Husqvarna GTH26K54 stands out in the lawn care market as a powerful, versatile, and user-friendly tractor. With its impressive features, advanced technologies, and commitment to comfort, it is an ideal choice for anyone looking to achieve a pristine lawn with minimal hassle.
Top Page Image Contents