Husqvarna GTH2250 Service and Adjustments, To Remove Mower See Fig, To Level Mower Housing

Page 20

SERVICE AND ADJUSTMENTS

CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

Depress clutch/brake pedal fully and set parking brake.

Place motion control lever in neutral (N) position.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key “OFF” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 20)

Place attachment clutch in “DISENGAGED” position.

Turn height adjustment knob to lowest setting.

Lower mower to its lowest position.

Remove retainer spring holding anti-swaybar to chassis bracket and disengage anti-swaybar from bracket.

Remove retainer springs from suspension arms at deck and disengage arms from deck.

Raise attachment lift to its highest position.

Remove two retainer springs from each front link and remove links.

Slide mower forward and remove belt from electric clutch pulley.

Slide mower out from under right side of tractor.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PROD- UCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 20 and 21)

Raise mower to its highest position.

Measure height from bottom of deck curl to ground level at front corners of mower. Distance “A” on both sides of mower should be the same.

If adjustment is necessary, make adjustment on one side of mower only.

To raise one side of mower, tighten lift link adjustment nut on that side.

To lower one side of mower, loosen lift link adjustment nut on that side.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.

TO INSTALL MOWER

Follow procedure described in “INSTALL MOWER AND DRIVE BELT” in the Assembly section of this manual.

BOTTOM

EDGE OF

MOWER TO

GROUND

AGROUND LINE

BOTTOM EDGE OF MOWER TO GROUND

A

ADJUSTMENT

 

FRONT

FIG. 21

NUTS

LIFT

SUSPENSION

ELECTRIC

 

BRACKET

 

LINKS

CLUTCH

SUSPENSION

 

 

 

PULLEY

ARMS

 

FRONT MOWER

 

 

 

 

 

 

BRACKET

 

CHASSIS

 

 

 

BRACKET

 

 

FRONT

 

 

 

SUSPENSION

 

 

 

BRACKET

 

 

 

FRONT

 

 

 

LINKS

 

 

 

RETAINER

RETAINER

 

 

SPRINGS

 

 

 

SPRING

 

 

 

ANTI-SWAY

 

 

FRONT MOWER

BAR

 

 

BRACKET

RETAINER

SPRINGS

FIG. 20

20

Image 20
Contents GTH2250 IV. Service General OperationII. Slope Operation III. ChildrenSafety Rules Safe Operation Practices for Ride-On MowersTable of Contents Unassembled Parts Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig To Attach Nose Roller See FigCheck Tire Pressure Check Mower LevelnessCheck for Proper Position of ALL Belts Check Brake SystemChecklist Operation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Operate on HillsTo Transport See Figs Towing Carts and Other ATTACH- MentsBefore Starting the Engine Check Engine OIL Level See FigADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionLubrication Chart Customer ResponsibilitiesGeneral Recommendations Before Each USETractor Engine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Level Mower HousingTo Install Mower To Remove Mower See FigTo Replace Mower Drive Belt To Replace Mower Blade Drive Belt See Fig To Adjust Attachment Clutch See FigTo Adjust Brake See Fig To Adjust Motion Control Lever See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN AdjustmentTo Remove Wheel for Repairs To Start Engine with a Weak Battery See FigFront Wheel Camber To Replace Fuse To Replace Headlight BulbInterlocks and Relays To Adjust Carburetor To Adjust Throttle Control Cable See FigTo Adjust Choke Control See Fig Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionOFF Service Notes Tractor - Model NO. GTH2250A Schematic Tractor - Model NO. GTH2250A ElectricalKEY Part Description Chassis and Enclosures 532177956 Ground Drive KEY Part NO. NO. Description Steering Assembly Adapter, Wheel Steering Engine Spark Arrester KITSeat Assembly Decals Wheels & TiresLift Assembly 532130171Mower Deck Wheel, Gauge Suggested Guide for Sighting Slopes for Safe Operation Warrantystatement Rev 4.27.01 JH/MH/JH/MH