Husqvarna EZ5224 / 966038301 manual Front Wheel Mount, Front Wheel Bearings, Deck Spindle

Page 46

LUBRICATION

Front Wheel Mount

Lubricate with a grease gun, one zerk for each wheel mount, until the grease is forced out.

Use only good quality bearing grease.

Grease from well-known brand names (petrochemical companies) usually maintains a good quality.

Front Wheel Bearings

Lubricate with a grease gun, one zerk for each set of wheel bearings, until the grease is forced out.

Use only good quality bearing grease.

IMPORTANT INFORMATION

Use minimal lubrication and remove excess lubricant so that is does not come into contact with belts or belt pulley drive surfaces.

8011-731

Lubricating the front wheels

Deck Spindle

Lower the cutting deck completely.

If a grease gun without a rubber hose is used, the foot plate must be removed.

Lubricate with a grease gun, one zerk, 2-3 strokes. Use only good quality bearing grease.

Deck Outer Spindle

Through the access hole in the belt shield, lubricate outer deck spindles zerk, using a grease gun and

2-3 strokes per side. Use only good quality bearing grease.

8011-732

Deck spindle

8061-035

Deck outer spindle

46

Image 46
Contents Operator Manual Page Contents Page Introduction Good Service Manufacturing NumberSymbols and decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxSymbols and decals Safety Safety InstructionsNever take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Controls Control LocationsSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuses Fuel Tank Fuel Shut Off Valve Cutting Height AdjusterAlways raise the deck to the highest position for transport Hour Meter Seat Adjustment LeverTracking Knob Training SteeringBefore Starting Starting the EnginePlace controls in neutral position Turn to the start position Weak Battery Connect one end of the Black cable toRunning Secure selected cutting heightOperating On Hills Set blade engagement and throttle controlMowing Tips Stopping the Engine Manual Transport ZT-2800 Bypass LinkagesMaintenance Maintenance ScheduleInterval Daily Once Hours Battery Replacing batterySafety System Fuel FilterFuel Pump Air Filter Tire PressuresBelts Deck Belt InstallationDeck Belt Removal Pump Belt Replacing pump belt Belt installationBelt removal Cutting Blades Adjusting the Mower Deck Leveling deckAnti-Scalp Rollers Caster Wheels CleaningUse protective glasses when cleaning and washing HardwareLubrication GeneralDeck Spindle Front Wheel MountFront Wheel Bearings Deck Outer SpindleTransaxle Transmission Fluid Change Purging Troubleshooting Problem CauseTroubleshooting Storage ServiceWinter Storage Schematics Accessories Technical DataTorque Specifications EZ4824K EZC4824 BF Engine TransmissionDimension EZ4824 EZC4824 BF FrameEZ5224 EZ5224BF Engine EZ5224 EZ5224BF Frame USA requirements CE requirementsDelivery Service Action Date, mtr reading, stamp, signHour Service After the first 5-8 hoursService Journal At Least Once Each Year Service Journal Service Journal Service Journal Page Page 115 387527R1 06/01/10