Husqvarna EZC4824BF / 966047501 manual Weak Battery, Connect one end of the Black cable to

Page 28

operation

Weak Battery

WARNING!

 

Lead-acid batteries generate

 

explosive gases. Keep sparks, flame

 

and smoking materials away from

 

batteries. Always wear eye protection

 

when around batteries.

 

IMPORTANT INFORMATION

 

Your mower is equipped with a 12-volt

 

negative grounded system. The other vehicle

 

must also be a 12-volt negative grounded

 

system. Do not use your mower to start other

 

vehicles.

 

If your battery is too weak to start the engine, it should

 

be recharged. (See “Battery” in the Maintenance

 

Section.)

 

If “jumper cables” are used for emergency starting,

 

follow this procedure:

 

Jumper Cables

 

• Connect each end of the RED cable to the

 

POSITIVE (+) terminal on each battery, taking

 

care not to short against chassis.

8011-642

• Connect one end of the BLACK cable to the

Jumper cable connection

 

NEGATIVE (-) terminal of the fully charged battery.

 

• Connect the other end of the BLACK cable to a

 

good CHASSIS GROUND on the mower with the

 

discharged battery, away from the fuel tank and

 

battery.

 

To remove cables, reverse order

Remove BLACK cable first from chassis and then from the fully charged battery.

Remove RED cable last from both batteries.

28

Image 28
Contents Operator Manual Page Contents Page Introduction Good Service Manufacturing NumberSymbols and decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxSymbols and decals Safety Safety InstructionsNever take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Controls Control LocationsSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuses Fuel Tank Fuel Shut Off Valve Cutting Height AdjusterAlways raise the deck to the highest position for transport Hour Meter Seat Adjustment LeverTracking Knob Training SteeringBefore Starting Starting the EnginePlace controls in neutral position Turn to the start position Weak Battery Connect one end of the Black cable toRunning Secure selected cutting heightOperating On Hills Set blade engagement and throttle controlMowing Tips Stopping the Engine Manual Transport ZT-2800 Bypass LinkagesMaintenance Maintenance ScheduleInterval Daily Once Hours Battery Replacing batterySafety System Fuel FilterFuel Pump Air Filter Tire PressuresBelts Deck Belt InstallationDeck Belt Removal Pump Belt Replacing pump belt Belt installationBelt removal Cutting Blades Adjusting the Mower Deck Leveling deckAnti-Scalp Rollers Cleaning Use protective glasses when cleaning and washingCaster Wheels HardwareLubrication GeneralFront Wheel Mount Front Wheel BearingsDeck Spindle Deck Outer SpindleTransaxle Transmission Fluid Change Purging Troubleshooting Problem CauseTroubleshooting Storage ServiceWinter Storage Schematics Accessories Technical DataTorque Specifications EZ4824K EZC4824 BF Engine TransmissionDimension EZ4824 EZC4824 BF FrameEZ5224 EZ5224BF Engine EZ5224 EZ5224BF Frame USA requirements CE requirementsDelivery Service Action Date, mtr reading, stamp, signHour Service After the first 5-8 hoursService Journal At Least Once Each Year Service Journal Service Journal Service Journal Page Page 115 387527R1 06/01/10