Husqvarna YTH2754XP owner manual Front Wheel TOE-IN/CAMBER, To Remove Wheel for Repairs See Fig

Page 24

SERVICE AND ADJUSTMENTS

G

H

B

A

C

J

D

E

F

02953 electric

FIG. 33

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

•Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

•Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 34)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 34

TO START ENGINE WITH A WEAK BATTERY (See Fig. 35)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WEAK OR DEAD

 

 

 

 

 

 

 

FULLY CHARGED

BATTERY

 

 

 

 

 

 

 

BATTERY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FIG. 35

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents YTH2754XP Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Battery Unassembled PartsMower Mower Front Wheel Slope SheetAssembly Tools Required for AssemblyTo Remove Tractor from Carton Unpack CartonInstall Mower and Drive Belt First Install ANTI-SWAY BAR S7/16 Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To USE Cruise Control -J See FigService REMINDER/HOUR Meter Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance Lubrication ChartBefore Each USE Battery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install MowerTractor See Fig To Remove MowerTurn nut right Turn nut left To raise mower To Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor Model NO. YTH2754XP 96041000501, Product no 41Electrical KEY Part NO. NO. Description Chassis Tractor Model NO. YTH2754XP 96041000501, Product no 41 Drive KEY Part Description Steering Assembly Spark Arrester KIT EngineSeat Assembly Decals Wheels and TiresMower Deck KEY Part NO. NO. Description Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement

YTH2754XP specifications

The Husqvarna YTH2754XP is a versatile and efficient riding mower designed for homeowners seeking a robust solution for maintaining their lawns. With its powerful features and user-friendly design, it stands out as an excellent choice for those looking to achieve a beautifully manicured lawn with minimal effort.

One of the standout features of the YTH2754XP is its 27-horsepower engine. Powered by a reliable Briggs & Stratton® motor, it provides ample power for tackling various lawn conditions, making it easy to cut through thick grass and navigate uneven terrains. The 54-inch cutting deck ensures a wide cutting path, enabling users to cover more ground in less time while delivering a clean, precise cut.

The cutting deck is constructed with high-quality materials, featuring a reinforced design that can withstand the rigors of frequent use. With three anti-scalp wheels, the deck maintains consistent height for an even cut, reducing the risk of grass scalping on uneven surfaces. Additionally, the deck's cutting height can be easily adjusted, allowing users to choose the perfect height for their specific grass type and growing conditions.

Husqvarna has incorporated several advanced technologies in the YTH2754XP to enhance the mowing experience. The automatic transmission allows for smooth acceleration and deceleration, making it easier to navigate tight spots and corners. The ergonomic steering wheel and comfortable seat ensure a pleasant ride, minimizing fatigue during longer mowing sessions.

The YTH2754XP also features a pedal-operated hydrostatic transmission, which offers seamless speed and direction changes without the need for manual clutching or shifting. This system allows for precise control and maneuverability, particularly in challenging landscaping areas.

In terms of maintenance, the YTH2754XP has been designed with user convenience in mind. The integrated deck wash system makes cleaning the underside of the cutting deck simple, preventing grass build-up that can affect cutting performance. Furthermore, the easy-access battery compartment and oil filter simplify routine maintenance tasks.

With its combination of power, durability, and innovative features, the Husqvarna YTH2754XP is a reliable choice for homeowners looking to invest in a quality riding mower that makes lawn care a breeze. Its blend of cutting-edge technology and user-friendly design ensures that even the most challenging mowing tasks can be accomplished with ease and efficiency.
Top Page Image Contents