CONNECTIONS
Choosing a Connection
The following shows examples of connections commonly used to connect the DVD player with a TV and other components.
Before Connecting the DVD Player
-Always turn off the DVD player, TV, and other components before you connect or disconnect any cables.
-Refer to the user’s manual of the additional components you are connecting for more information on those particular components.
Connection to a TV (For Video)
English
1
Using video/audio cables, connect the VIDEO
(yellow)/AUDIO (red and white) OUT terminals on the rear of the DVD player to the VIDEO (yellow)/AUDIO (red and white) IN terminals of TV.
2
Turn on the DVD player and TV.
RED | WHITE | YELLOW |
| Audio Cable | Video Cable |
|
| |
RED | WHITE | YELLOW |
3
Press the input selector on your TV remote control until the Video signal from the DVD player appears on the TV screen.
Note
-Noise may be generated if the audio cable is too close to the power cable.
-If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 14 to 15)
-The number and position of terminals can vary depending on your TV set. Please refer to the user's man- ual of the TV.
-If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of the DVD player.
-If you press the VIDEO SEL. button when DVD Player is in stop mode or no disc is inserted, the Video Output mode changes in the following sequence: (PROGRESSIVE ON ➝ PROGRESSIVE OFF)
-If you set the HDMI output resolution 720p or 1080i,
9