Troubleshooting
Before requesting service (troubleshooting), please check the following.
| Problem |
| Action | Page | ||
|
| • | Check the batteries in the remote control. |
|
| |
No operations can be |
| They may need replacing. |
|
| ||
• | Operate the remote control at a distance of no more than 20 feet. | P3 | ||||
performed with the | • | Remove batteries and hold down one or more buttons for several minutes to drain | ||||
|
| |||||
remote control. |
| the microprocessor inside the remote control to reset it. Reinstall batteries and try |
|
| ||
|
|
| to operate the remote control again. |
|
| |
|
|
|
|
| ||
Disc does not play. | • | Ensure that the disc is installed with the label side facing up. | P5 | |||
|
| • | Check the region number of the DVD. |
|
| |
|
| • 5.1 channel sound is reproduced only when the following conditions are met. : |
|
| ||
5.1 channel sound is |
| 1) The DVD player is connected with the proper Amplifier | P14~15 | |||
| 2) The disc is recorded with 5.1 channel sound. | |||||
not being reproduced. |
|
|
| |||
• | Check whether the disc being played has the “5.1 ch” mark on the outside. |
|
| |||
|
|
|
| |||
|
| • | Check if your audio system is connected and working properly. | P27~28 | ||
|
| • | In a SETUP Menu, is the Audio Output set to Bitstream? |
|
| |
|
| • | The features or action cannot be completed at this time because: |
|
| |
The | icon appears | 1. The DVD’s software restricts it. |
|
| ||
on screen. | 2. The DVD’s software doesn’t support the feature (e.g., angles). |
|
| |||
|
| 3. The feature is not available at the moment. |
|
| ||
|
| 4. You’ve requested a title or chapter number or search time that is out of range. |
|
| ||
Disc Menu doesn’t appear. • Check if the disc has a Menu.
Play mode differs from the | • | Some of the functions selected in the Setup Menu may not work properly if the | P26~30 | |||
Setup Menu selection. |
| disc is not encoded with the corresponding function. |
| |||
|
|
|
|
|
| |
The screen ratio | • | The Screen Ratio is fixed on your DVDs. | P28~29 | |||
cannot be changed. | ||||||
|
|
|
|
| ||
No audio. | • | Make sure you have selected the correct Digital Output in the Audio Options | P27~28 | |||
|
| Menu. |
|
|
| |
The screen is blocked | • | Press the |
| button (in front panel) for more than 5 seconds under no disc inside. | P16 | |
| ||||||
| All settings | will revert to the factory settings. | ||||
|
|
|
|
|
| |
Forgot password | • | Press the |
| button (in front panel) for more than 5 seconds |
| |
|
| |||||
|
| |||||
| under no disc inside. All settings including the password will revert to the factory | P30 | ||||
|
| settings. Don't use this unless absolutely necessary. |
| |||
|
|
|
|
| ||
If you experience | • | Go to the contents and find the section of the instruction book that contains the |
| |||
| explanations regarding the current problem, and follow the procedure once again. |
| ||||
other problems. |
|
| ||||
• | If the problem still cannot be solved, please contact your nearest authorized ser- |
| ||||
|
| |||||
|
| vice center. |
|
|
| |
|
|
|
|
| ||
The picture is noisy or | • | Make sure that the disc is not dirty or scratched. | P2 | |||
distorted | • | Clean the disc. | ||||
No HDMI output. | • | Check the Video output is HDMI enabled. | P13~14 | |||
| • | Check the connection between the TV and the HDMI jack of DVD player. | ||||
|
| |||||
| • | See if the TV supports this 480p/576p/720p/1080i DVD player. |
| |||
Abnormal HDMI output | • | If snow noise appears on the screen, it means that TV does not support HDCP | P13~14 | |||
screen. |
|
| ||||
HDMI output Jitter | • | Check your TV system setup correctly. |
| |||
| • | The screen Jitter phenomenon may occur when frame rate is converted from | P29 | |||
|
| 50Hz to 60Hz for 720P/1080i HDMI (High Definition Multimedia Interface) Output. | ||||
| • | Please refer to the user’s manual of your TV. |
| |||
32