CONNECTIONS

Choosing a Connection

The following shows examples of connections commonly used to connect the DVD player with a TV and other components.

Before Connecting the DVD Player

-Always turn off the DVD player, TV, and other components before you connect or disconnect any cables.

-Refer to the user’s manual of the additional components you are connecting for more information on those particular components.

Connection to a TV (For Video)

English

1

Using video/audio cables, connect the VIDEO

(yellow)/AUDIO (red and white) OUT terminals on the rear of the DVD player to the VIDEO (yellow)/AUDIO (red and white) IN terminals of TV.

2

Turn on the DVD player and TV.

RED

WHITE

YELLOW

 

Audio Cable

Video Cable

 

 

RED

WHITE

YELLOW

3

Press the input selector on your TV remote control until the Video signal from the DVD player appears on the TV screen.

Note

-Noise may be generated if the audio cable is too close to the power cable.

-If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 14 to 15)

-The number and position of terminals can vary depending on your TV set. Please refer to the user's man- ual of the TV.

-If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of the DVD player.

-If you press the VIDEO SEL. button when DVD Player is in stop mode or no disc is inserted, the Video Output mode changes in the following sequence: (PROGRESSIVE ON PROGRESSIVE OFF)

-If you set the HDMI output resolution 720p or 1080i, Video/S-Video and component output cannot be used.

9