4.Press the input selector on your TV remote control until the DVI signal from the DVD Recorder appears on your TV screen.
J Depending on the HDMI device (TV/HDMI Receiver) you use, audio may not be supported. If TV does not support Dolby digital/DTS, Audio output is not available when you set Digital output as Bitstream or select DTS On in Audio setup menu. In this case, set the digital audio output to PCM or DTS Off.
If your TV has a HDMI/DVI input, connect HDMI/ DVI cable to a TV. You will enjoy the best quality images and sounds.
Please check the
red
(not supplied)
red | white |
-Though the DVD recorder uses a HDMI cable, the DVD recorder outputs only a pure digital signal to the TV.
-If TV does not support HDCP
Why does Samsung use HDMI?
Analogue TVs require an analogue video/audio signal.However, when playing a DVD, the data transmitted to a TV is digital. Therefore either a
What is the HDCP?
HDCP
Up Setting & onnectingC
M If the DVD Recorder is connected to your TV in HDMI 1080p output mode, you must use High speed(category2) HDMI cable.
To change HDMI output resolution, see page 35.
HDMI (High Definition Multimedia Interface) HDMI is an interface to enable the digital transmission of video and audio data with just a single connector. Since HDMI is based on DVI, it is completely compatible with DVI. The only difference between HDMI and DVI is that HDMI supports
Using HDMI, the DVD recorder transmits a digital video and audio signal and displays a vivid picture on a TV having an HDMI input jack.
HDMI connection description
HDMI connector - Both uncompressed video data and digital audio data (LPCM or Bit Stream data).
English - 21