3.Straighten a supplied speaker wire to the gravity direction and put in the hole on the centre of Stand Base.
4.Connect the upper Speaker to the assembled Stand.
5.Insert a screw clockwise into the hole on the rear of the speaker using a screwdriver.
And then connect a speaker cable.
6.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
Connecting The Speakers34
Speaker
Stand
56
Connections 03
1.Match each speaker cable bundle to the correct speaker by matching the colour coded
plug on each bundle to the coloured sticker on the bottom of each speaker.
2. To attach speaker wire to each speaker:
a. Press down the red tab on the back of the speaker, insert the red wire, and then release the tab.
b. Press down the black tab on the back of the speaker, insert the black wire, and then | Black | Red |
release the tab. |
|
|
3. Connect the speaker wire plugs from each speaker to the back of the product by matching the colours of the speaker plugs to the colours of the speaker jacks.
* In case of
Surround Speaker (R) |
|
|
|
| Surround Speaker (L) |
Front Speaker (R) | SURROUND | R | SURROUND L | 3 | Front Speaker (L) |
|
|
| : | ||
| FRONT R |
| FRONT L | IMPEDANCE |
|
| SUBWOOFER | CENTER |
|
| |
| SPEAKERS OUT |
|
| ||
Subwoofer |
|
|
|
| Centre Speaker |
SURROUND SURROUND | : 3 |
|
| ||
| FRONT | FRONT | IMPEDANCE |
|
|
| SUBWOOFER | CENTER |
|
|
|
| SPEAKERS OUT | HDMI OUT |
|
1.Connect the left and right surround speakers to the wireless receiver module. Again, match the colour of the plugs to the jacks on the wireless receiver module.