Samsung HT-DS470 HTDS470RH/EDC Connecting the Video Out to TV, For using the SCART cable, If Scart is equipped for your TV, set, METHOD 2Scart ............... Better Quality

1p~38p(DS470)-GB 9/16/04 9:35 AM Page 16

Connecting the Video Out to TV

Make sure that turn off and disconnect the plug from outlet before moving or installing the product. In connecting to video, select one of following three methods that suits for TV and connect it.

IMPEDANCE SUBWOOFER : 4Ω

FRONT / CENTER / REAR : 4Ω

CENTER

SUBWOOFER

METHOD 3

METHOD 1

METHOD 2

TV

VIDEO	COMPONENT	SCART
IN	IN	IN

METHOD 1 Composite Video ............... Good Quality

Connect the supplied video cable from the VIDEO OUT jack on the back panel of the system to the VIDEO IN jack on your television.

METHOD 2 Scart ............... Better Quality

If you television is equipped with an SCART input, connect an Scart Jack (not supplied) from the AV OUT jack on the back panel of the system to the SCART IN jack on your television.

For using the SCART cable

•If Scart is equipped for your TV, set RGB-COMPOSITE selector of the center unit to RGB. You can get a better picture quality by using Scart setting.

•If Scart (RGB Input) is not equipped for your TV, set RGB-COMPOSITE selector to COMPOSITE.

RGB COMPOSITE

RGB

COMPOSITE

METHOD 3 Component (Progressive Scan) Video ............... Best Quality

If your television is equipped with Component Video inputs, connect a component video cable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to the corresponding jacks on your television.

Note • When the Progressive scan mode is selected, the VIDEO and SCART outputs do not feed any signal. See page 14 to select Progressive Scan.

13