Samsung C23A550U 2.5.1 Dynamic IP, Dynamic IP User, Using "HUB Monitor, 2Using "HUB Monitor

2Using "HUB Monitor"

To use the Internet using the HUB Monitor’s LAN network, configure the network settings as follows

according to the type of IP you will be using.

2.5.1 Dynamic IP

The dynamic IP address mode automatically configures the network settings on the PC using data sent by a server, which allots an IP address. This is possible, owing to the “DHCP (Dynamic Host Configuration Protocol)” service. The service consists of three steps: an IP address allotment request is sent to the DHCP server when the PC boots up, the DHCP server that received the request transmits network information such as the IP address to the PC, and the transmitted network information is automatically registered to the network settings on the PC. The DHCP service is convenient and useful especially in an environment where multiple PCs are used. Theoretically, the IP address changes each time the PC boots up (or an IP allotment request is sent); in many cases, however, the existing IP address is re-allotted. An Internet router performs two roles: creating a private IP address (NAT service) and automatically allotting the IP address to each PC (DHCP service) at the same time.

When using your HUB Monitor’s or notebook PC’s LAN network, ensure you insert a LAN cable into

only one device. Otherwise, a system crash may occur.

Dynamic IP User

1To use a dynamic IP address, connect a LAN to your HUB Monitor.

2Next, go to the network settings menu and activate the HUB Monitor’s network device (select “Use”).

Go to Control Panel → Network and Internet ￿ Network and Sharing Center Change

adapter settings. Next, right-click on the HUB Monitor’s network device (marked “LAN9512/ LAN9514 USB 2.0 to Ethernet 10/100 Adapter #7”) and select Use.

3Using the network properties menu, check that the IP address mode for the HUB Monitor’s network device is set to Auto.

2 Using "HUB Monitor" 31