• 6.35 mm compression nut | • copper tubing |
• plastic tubing | • ferrule |
Refrigerator | |
| Compression nut |
Plastic tubing | (6.35 mm) (Supplied) |
(Supplied) |
|
| Compression fitting |
| (Supplied) |
Ferrule | Bulb |
| |
(Not supplied) |
|
| Compression nut |
| (6.35 mm) |
| (Not supplied) |
Copper tubing or Plastic tubing | |
(Not supplied) | (Not supplied) |
Household water line
1.Slip the compression nut through the supplied plastic tubing
2.Tighten the compression nut
-If you are using copper tubing, slip the compression
nut
-If you are using plastic tubing
Do not use without the molded end(Bulb) of the plastic tubing
3.Tighten the compression nut
4.Turn water on and check for any leakage.
Only connect the water line to a drinkable water source. If you have to repair or disassemble
the water line, cut off 6.35 mm of the plastic tubing to make sure you get a snug,
Installing the water filter.
1. Remove the water fi lter cover 1 .
2.Remove the fi xed cap by turning it counter clockwise. Keep the cap in a safe place for later use if you don’t use the fi lter.
3.Remove the water fi lter from the box and put a replacement indicator sticker on the fi lter as shown. Place the sticker on the fi lter that dates six months in the future. For example, if you install the water fi lter in March, put the “SEP” sticker on the fi lter to remind you to replace it in September. That way you’ll know when it is time to replace the fi lter. Normally, a fi lter life is about 6 months.
1
2 | 3 |
Sticker
(month indicator)
4.Remove the fi lter cap and insert the fi lter into the
filter housing.
5.Slowly turn the water fi lter 90º clockwise to align with the printing mark on the cover, locking the
filter in position.
Make sure to align the water fi lter label mark with center of cover fi lter printing as illustrated. Remember, do not overtighten.
4 | Cover filter 5 |
| Turn until |
| the label is |
Separation | aligned. |
of red cap. |
|
You should remove the right side upper glass shelf before installing the water fi lter.
Removing any residual matter inside the water supply line after installing the water filter.
1.Turn ON the main water supply & turn OFF the valve to the water supply line.
2.Run water through the dispenser until the water runs clear (approx.
3.Additional fl ushing may be required in some households.
4.Open the Refrigerator door and make sure there are no water leaks coming from the water fi lter.
Be sure to fl ush the dispenser thoroughly or water may leak from it. This is due to the fact
that there is still air in the line.
Setting up _19
2017. 7. 26. 3:27 |