Samsung WA186DSHASU/YL installing your washer, Test run, Rinse+Spin

installing your washer

2.Check the inlet hoses to ensure a washer is inside the coupling of each fill hose.

Thread the inlet hoses onto the HOT and COLD faucet connections.

On the other end of the hose, check for one rubber washer per hose and attach each fill hose to the water valve. Make sure the hose with Hot printed on it is attached to the HOT faucet. Tighten by hand until snug, then add two-thirds of a turn with pliers.

For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an “4E” (no fill) error can occur.

Cold Hot

Rubber Washer

Cold printed Hot printed

3. Turn on the “HOT” and “COLD” water supplies and check all the water valve and the faucet connections for leaks.

4.Plug the power cord into a 3-Prong, well grounded 220 V / 60 Hz approved electrical outlet protected by a comparable circuit breaker.

Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded receptacle.

5.Slide your washer into position.

6.Level your washer by turning the leveling legs in or out as necessary by hand.

Your Washer must be level back to front and side to side. Use a carpenter’s level on all four corners of your Washer to level it. It’s a good idea after the first dozen washes to recheck your washer to ensure it is still level.

Test run

Make sure that you install your washing machine correctly by running the Rinse+Spin cycle after the installation is complete.

16_ installing your washer

WA186DSHASU-02703E_EN_130131.indd Sec3:16 2013-01-31 ￿￿ 5:57:36