Samsung WF520ABP/XAA washer your installing, Plug the power cord into a, installing your washer _17, 5.Slide your washer into position

2.Check the inlet hose to ensure a washer is inside each fill hose.Thread the inlet hoses to the HOT and COLD faucet connections.

On the other end of the hose, check for one rubber washer per hose and install each fill hose to the water valve. Make sure the hose with the Hot printed line is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers.

For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an “nF” (no fill) error can occur.

3.Turn on the “HOT” and “COLD “water supply and check all connections at the water valve and the faucet for leaks.

4.Plug the power cord into a 3-Prong, well grounded 120 volt 60 Hz approved electrical outlet protected by a 15-amp fuse or comparable circuit breaker.

Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded receptacle.

5.Slide your washer into position.

6.Level your washer by turning the leveling legs in or out as necessary by hand or by using the wrench included with your washer.

When your washer is level, tighten the locking nuts using the wrench or (-) flathead screwdriver.

Your Washer must be leveled on all four sides. A carpenter’s level should be used on all four corners of your Washer. It’s a good idea after the first dozen washes to recheck your washer’s levelness.

Avoid damage to the legs. Do not move the Washer unless the Locking-nuts are fastened to the bottom of the Washer.

Cold Hot

Rubber Washer

Cold printed Hot printed

Locking Nut

Levelling Leg

washer your installing 01

installing your washer _17

WF520AB-02838B-08_EN.indd Sec3:17 2012-05-11 ￿￿ 3:34:01