troubleshooting
Error Image | MEANING | SOLUTION | |
| Your washer has tried to fill but was | Make sure the water faucets are open | |
| unsuccessful. | all the way. Check for kinked hoses. | |
|
| Check the inlet screens on the fill | |
|
| hoses. | |
|
| If you use a Flood Safety Device, then | |
Low Water Pressure |
| please remove the device and connect | |
|
| the water hoses directly to the unit. | |
|
|
| |
| Check if the hot water supply hose is | You must connect the hot water supply | |
| connected. | hose because hot water is supplied by | |
|
| the Auto Temperature Control (A.T.C.) | |
|
| function if the temperature of the cold | |
|
| water is lower than 59°F. | |
Water Temperature Control | The hot/cold water hose connection is | Please connect the hot/cold water | |
not correct. | hose connection correctly. | ||
Problem | |||
| |||
|
|
| |
Power Interruption | Problem with control. | Call for service. | |
|
| ||
|
|
| |
Water Supply Problem | A fault is detected in the water level | Call for service | |
sensor. |
| ||
|
| ||
|
|
| |
A Button is either stuck or is | Jammed key. | Call for service | |
|
| ||
being pressed continuouly. |
|
| |
|
|
| |
The Motor is not working | Motor problem | Restart the cycle | |
|
| ||
properly. |
| If the code reappears, call for service | |
|
| ||
|
|
| |
Temperature Sensor | Temperature sensor problem. | Restart the cycle. | |
|
| ||
Problem |
| If the code reappears, call for service. | |
|
| ||
|
|
| |
High/Low Voltage Detected | High/Low voltage detected. | Restart the cycle. | |
|
| ||
|
| If the code reappears, call for service. | |
|
|
| |
Electronic Control Problem | Communication error between SUB | Call for service | |
PBA and MAIN PBA |
| ||
|
| ||
|
|
| |
Front MEMS Sensor Problem | Front MEMS sensor problem | Call for service | |
|
| ||
|
|
| |
Rear MEMS Sensor Problem | Rear MEMS sensor problem | Call for service | |
|
| ||
|
|
| |
| Too many suds are detected during the | To prevent it, cut down on detergents. | |
| washing session. |
| |
| The unit is put on hold until the suds |
| |
Excessive Suds | are reduced. Then, the unit will go back |
| |
| to the operation. |
| |
| When it finishes washing, “End” and |
| |
| “Excessive Suds” codes will blink in |
| |
| turn. |
| |
|
|
|
For any codes not listed above, call
36_ troubleshooting
|
| ||
|
| ||
|
|
|
|