117
11
EQ and Dynamics
LS9-16/32 Owner’s Manual
6If you want to use the high-pass filter on an
input channel, operate the HPF FREQ knob
or HPF ON/OFF button in the ATT/HPF/EQ
popup window.
Input channels provide a high-pass filter that is inde-
pendent of the four-band EQ. Use the HPF ON/OFF
button to switch the high-pass filter on/off, and use the
HPF FREQ knob to specify the cutoff frequency.
7If you want to initialize EQ settings or copy
them to another channel, use the tool but-
tons in the ATT/HPF/EQ popup window.
For details on how to use these buttons, refer to “Using
the tool buttons” (→ p. 35).
Input channels provide two dynamics processors, and output channels provide one dynamics
processor.
1Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1DYNA1 popup button
BDYNA2 popup button (input channels only)
2Use the LAYER section to select the desired
fader layer.
3Press a [SEL] key in the channel module
section, STEREO MASTER section, or ST IN
section to select the channel that you want
to operate.
4In the screen, move the cursor to the
DYNA1/DYNA2 popup button or any knob in
the DYNA1/DYNA2 field, and press the
[ENTER] key.
The DYNAMICS 1/DYNAMICS 2 popup window
will appear. In this popup window you can view and
edit all dynamics parameters of the currently selected
channel.
• Output channels do not provide a high-pass filter that is inde-
pendent of the EQ. However by turning on the high-pass filter
button in the popup window, you can use the LOW band EQ
as a high-pass filter.
•For both input channels and output channels, you can turn on
the low-pass filter button and use the HIGH band EQ as a
low-pass filter.
HINT
•You can also use a dedicated library to save or load EQ set-
tings at any time (
→
p. 120). You can also take advantage of a
wide variety of presets suitable for various instruments or situ-
ations.
•You can also use the encoders of the SELECTED CHANNEL
section to adjust the EQ or high-pass filter (
→
p. 87).
HINT
Using dynamics
12
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
→
p. 194), you
can also access the above popup window by pressing any of
the [DYNAMICS 1]/[DYNAMICS 2] encoders while the
SELECTED CH VIEW screen is shown.
HINT
Using EQ • Using dynamics