155
LS9-16/32 Owner’s Manual
16
Meters
Chapter 16
Meters
This chapter describes the meter screen which displays input/output level
meters for all channels.
By accessing the Meter screen you can view the input/output levels of all channels in the screen,
and switch the metering point (the location at which the level is detected) of the level meters.
1In the DISPLAY ACCESS section, press the
[METER] key to access the Meter screen.
The Meter screen is divided into the METER CH1-32
screen, {METER CH 33-64 screen}, OUTPUT
METER screen, and CUSTOM FADER screen.
[ METER CH1-32 screen ]
[ OUTPUT METER screen ]
[ CUSTOM FADER screen ]
1Metering point select buttons
Use these three buttons to select the metering point for
the input/output channels.
BLevel meters
These show the input/output levels or fader values.
The current fader value is shown in a range of -∞–10.
When you operate the corresponding fader, the value
will change in realtime.
The ∑ segment will light if even one of the level detec-
tion points within each channel is overloaded.
The ∑ segment level detection points are as follows.
• Input channels
...........PRE HPF, PRE FADER, POST ON
• Output channels
...........PRE EQ, PRE FADER, POST ON
CPEAK HOLD button
If you turn this button on, the peak levels of the meters
will be held. When you turn this button off, the peak
level indications that had been held will be cleared.
Using the METER screen
1
2
3
1
3
2
4
2
LS9-16
5