1. Manuals
  2. Brands
  3. Musical Instruments & Equipment
  4. Music Mixer
  5. Yamaha
  6. Musical Instruments & Equipment
  7. Music Mixer

Yamaha 007POTO-G0, WH39070 - page 151

1 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 290
Download on canonical page 290 pages, 6.75 Mb
151
LS9-16/32 Owner’s Manual
15
Talkback / Oscillator
Chapter 15
Talkback / Oscillator
This chapter explains how to use the talkback and oscillator functions.
Talkback is a function that sends the signal of the selected INPUT jack to the desired bus. This is
used mainly to convey directions from the operator to the performers and staff. The LS9 also con-
tains an oscillator that allows a sine wave or pink noise to the desired bus, and this can be used
to check external equipment or to test the response of the room.
The diagram below shows the signal flow of the talkback and oscillator.
Here’s how a signal received at an INPUT jack 1–16 {1–32} can be output to the desired bus.
1In the DISPLAY ACCESS section, press the
[MONITOR] button repeatedly to access the
TALKBACK screen.
In the TALKBACK screen you can check the status of
the talkback and turn it on/off.
1TALKBACK ON button
This switches talkback on/off.
BINPUT TO TALKBACK field
Of the INPUT jacks 1–16 {1–32}, the input sensitiv-
ity, input level, and phantom power on/off status of the
jack used for talkback is shown here. You can adjust
the input sensitivity by selecting the GAIN knob in
this field.
Input select popup button
This displays the INPUT PORT SELECT popup
window, where you can select the INPUT jack
used for talkback.
+48V button
This is an on/off switch for the phantom power
(+48V) supplied to the INPUT jack used for talk-
back.
GAIN knob
This adjusts the input sensitivity of the INPUT
jack used for talkback.
Input level meter
This indicates the input level of the mic connected
to the INPUT jack used for talkback.
CASSIGN field
This selects the buses to which the talkback signal will
be sent. If you want to clear all selections, move the
cursor to the CLEAR ALL button and press the
[ENTER] key.
About talkback and oscillator
TALKBACK
ON
INPUT 1-16{32}
12
... ...
1516
ST
LR
MATRIX CUE
ON
+48V
AD
[INPUT]
+
-
12
3
METER
HA ON
METER
GAIN/TRIM
[1-16{32}]
INPUT
+48V
+48V MASTER INPUT
SELEECT
OSCILLATOR
Sine Wave
Pink Noise
Burst Noise HPF LPF
LEVEL
OSC
MIX
M
O
N
O
(C) 12 78 LR
Using talkback
1
3
2
MENU

Models

Contents