156
Using the METER screen
LS9-16/32 Owner’s Manual
DMetering point select box
Use the dial or the [DEC]/[INC] keys to select the
metering point for the input/output channels.
EChannel name
This shows the first four characters of the channel
name for the channels assigned to the [CUSTOM
FADER] layer. Channels that are not assigned are
shown as “----”.
2If desired, you can move the cursor to the
metering point select buttons and press the
[ENTER] key to switch the metering point.
In the CUSTOM FADER screen, move the
cursor to the metering point select box, use
the dial or the [DEC]/[INC] keys to make
your selection, and then press the [ENTER]
key.
The metering point for the level meters can be set
independently for input channels and output channels.
You can choose from the following metering points.
●Input channels
• PRE HPF............ Immediately before the high-
pass filter
• PRE FADER....... Immediately before the fader
• POST ON ...........Immediately after the [ON] key
●Output channels
• PRE EQ.............. Immediately before the
attenuator
• PRE FADER....... Immediately before the fader
• POST ON ...........Immediately after the [ON] key
For details on the metering points, refer to the block
diagram at the end of this manual.
3If you want to hold the peak levels of the
level meters, move the cursor to the PEAK
HOLD button and press the [ENTER] key to
turn it on.
On/off operations of the PEAK HOLD button will
apply to both input channels and output channels.
When you turn this button off, the peak level indica-
tions that had been held will be cleared.
•You can also assign the PEAK HOLD button on/off function to
a user-defined key (
→
p. 196).
•If you turn on METER FOLLOW LAYER in the PREFERENCE
screen, the same meter screen as the selected layer will be
displayed when you press a LAYER key.
HINT